Search results
Results from the WOW.Com Content Network
A USB device pulls one of the data lines high with a 1.5 kΩ resistor. This overpowers one of the 15 kΩ pull-down resistors in the host and leaves the data lines in an idle state called J. For USB 1.x, the choice of data line indicates what signal rates the device is capable of: full-bandwidth devices pull D+ high,
The USB mass storage device class (also known as USB MSC or UMS) is a set of computing communications protocols, specifically a USB Device Class, defined by the USB Implementers Forum that makes a USB device accessible to a host computing device and enables file transfers between the host and the USB device. To a host, the USB device acts as an ...
Class definitions for Communication Devices 1.2 (.zip file format, size 3.43 MB) Class definitions for Communication Devices 1.1; App Note, Migrating from RS-232 to USB Bridge Specification. Explains the use of USB CDC (Communications Device Class) ACM (Abstract Control Model) to emulate serial ports over USB.
USB 3.2, released in September 2017, [35] preserves existing USB 3.1 SuperSpeed and SuperSpeedPlus architectures and protocols and their respective operation modes, but introduces two additional SuperSpeedPlus operation modes (USB 3.2 Gen 1×2 and USB 3.2 Gen 2×2) with the new USB-C Fabric with signaling rates of 10 and 20 Gbit/s (raw data ...
Goals stated in the USB4 specification are increasing bandwidth, helping to converge the USB-C connector ecosystem, and "minimize end-user confusion". Some of the key areas to achieve this are using a single USB-C connector type, to offer display and data transfer features, while retaining "compatibility with existing and Thunderbolt products ...
Display Transfer Characteristics Data Block (DTCDB) (A7, AF, BF) Block Map (F0) Display Device Data Block (DDDB) (FF): contains information such as subpixel layout [6] Extension defined by monitor manufacturer (FF): According to LS-EXT, actual contents varies from manufacturer. However, the value is later used by DDDB.
Ethernet over USB is the use of a USB link as a part of an Ethernet network, resulting in an Ethernet connection over USB (instead of e.g. PCI or PCIe).. USB over Ethernet (also called USB over Network or USB over IP) is a system to share USB-based devices over Ethernet, Wi-Fi, or the Internet, allowing access to devices over a network.
In July 2012, the USB Promoters Group announced the finalization of the USB Power Delivery (USB-PD) specification (USB PD rev. 1), an extension that specifies using certified PD aware USB cables with standard USB Type-A and Type-B connectors to deliver increased power (more than 7.5 W maximum allowed by the previous USB Battery Charging ...