Search results
Results from the WOW.Com Content Network
Second gear is recommended for starts on snow and ice, as the available torque is lowered thus preventing wheel slip. The police package (9C1) B-body cars featured a First Gear Block Out (FGBO) Plate on the transmission housing to prevent drivetrain damage. The shift point for first to second gear is about 43 MPH (69 km/h) while second to third ...
The first through fourth gears are accessed when a low range is selected. To access the fifth through eighth gears, the range selector is moved to high range, and the gear lever again shifted through the first through fourth gear positions. In high range, the first gear position becomes fifth, the second gear position becomes sixth, and so on.
The 4L80-E uses two shift solenoids, initially called Shift Solenoid A and Shift Solenoid B; they were later changed to comply with OBD-II regulations to 1-2 shift solenoid and 2-3 shift solenoid. By activating and deactivating the solenoids in a predetermined pattern by the PCM, four distinct gear ratios can be achieved.
Push-button gear selector in a 2010–2014 Mitsubishi Fuso Aero Star bus. Many transmissions also include positions to restrict the gear selection to the lower gears and engages the engine brake. These positions are often labelled "L" (low gear), "S" (second gear) or the number of the highest gear used in that position (eg 3, 2 or 1).
The Honker II, a midget racing car, getting a push start at the 144th Wagga Wagga Show. A group of people attempting to push start a motorcycle.. Push starting, also known as, roll starting, clutch starting, popping the clutch or crash starting, is a method of starting a motor vehicle with an internal combustion engine that has a manual transmission, a mechanical fuel pump, and a mechanically ...
The 6L 50 (and similar 6L 45) is a 6-speed longitudinally-mounted automatic transmission produced by General Motors.It is very similar in design to the larger GM 6L 80 and 6L 90, and is produced at GM Powertrain plants in Toledo, Ohio; Silao, Guanajuato, Mexico; and by the independent Punch Powerglide company in Strasbourg, France.
The system was activated by moving the gearshift from the "D" position down to "2nd". The car would then start in 2nd gear, and not 1st. The transmission also splits the delivered torque 50-50 between the front and rear wheels. Once the car stopped, the transmission would start back in 2nd and not 1st, until the system was upshifted to 4th.
A dog-leg gearbox or dogleg gearbox is a manual transmission shift pattern distinguished by an up-over-up shift between first and second gear. [1] The layout derives its name from a dog's hind leg, with its sharp angles. Dog leg gearboxes were replaced in most mass production vehicles by transmissions with a standard gear layout.