Ads
related to: boat bilge pump with float switch and grinder motorebay.com has been visited by 1M+ users in the past month
walmart.com has been visited by 1M+ users in the past month
Search results
Results from the WOW.Com Content Network
A bilge pump is a water pump used to remove bilge water. Since fuel can be present in the bilge, electric bilge pumps are designed to not cause sparks. Electric bilge pumps are often fitted with float switches which turn on the pump when the bilge fills to a set level. Since bilge pumps can fail, use of a backup pump is often advised. The ...
For some modern types of dinghies in sailing sports hand bailers can be obsolete when they are equipped with self bailers, sometimes also called automatic bailers. Self-bailing boats are shaped so that they will drain completely if filled with water; powered by the venturi effect and the motion of the boat, they are distinct from the powered bilge pumps used on non-self-bailing boats.
Bilge compartment in a steel hulled ship (looking down) Bilge compartment and pump. The bilge / b ɪ l dʒ / of a ship or boat is the part of the hull that would rest on the ground if the vessel were unsupported by water. The "turn of the bilge" is the transition from the bottom of a hull to the sides of a hull.
A pedestal sump pump with a float switch. A float switch is a type of level sensor, a device used to detect the level of liquid within a tank. The switch may be used to control a pump, as an indicator, an alarm, or to control other devices. One type of float switch uses a mercury switch inside a hinged float. Another common type is a float that ...
The most prevalent hydraulic pump used in maritime situations in ancient Rome was the bilge pump, which functioned to siphon collected water out of a ship's hull (Oleson 1984). The bilge pump was an improvement on the first hydraulic pumps used in antiquity: force pumps.
Dry running protection, also known as dry-run protection or dry-running protection, is a type of protection mechanism to prevent a rotor, pump or stirrer shaft from operating without any medium added, as the bearing and shaft seal might be damaged if the motor is run while dry. [1]
A limber hole is a drain hole through a frame or other structural member of a boat designed to prevent water from accumulating against one side of the frame, and allowing it to drain toward the bilge. Limber holes are common in the bilges of wooden boats. The term may be extended to cover drain holes in floors.
A switch mounted in the motor turns the motor on as the water level in the basin rises, and shuts it off when the basin is empty; this automatic level control permits operation of the pump without constant monitoring. In a submersible pump, the motor is sealed in a special housing, with the impeller mounted directly to the shaft. Automatic ...
Ads
related to: boat bilge pump with float switch and grinder motorebay.com has been visited by 1M+ users in the past month
walmart.com has been visited by 1M+ users in the past month