Search results
Results from the WOW.Com Content Network
Throughput is controlled by available bandwidth, as well as the available signal-to-noise ratio and hardware limitations. Throughput for the purpose of this article will be understood to be measured from the arrival of the first bit of data at the receiver, to decouple the concept of throughput from the concept of latency.
The network throughput of a connection with flow control, for example a TCP connection, with a certain window size (buffer size), can be expressed as: Network throughput ≈ Window size / roundtrip time. In case of only one physical link between the sending and transmitting nodes, this corresponds to:
Reasons for measuring throughput in networks. People are often concerned about measuring the maximum data throughput in bits per second of a communications link or network access. A typical method of performing a measurement is to transfer a 'large' file from one system to another system and measure the time required to complete the transfer or ...
In a network simulation model with infinite packet queues, the asymptotic throughput occurs when the latency (the packet queuing time) goes to infinity, while if the packet queues are limited, or the network is a multi-drop network with many sources, and collisions may occur, the packet-dropping rate approaches 100%.
In data communications, the bandwidth-delay product is the product of a data link's capacity (in bits per second) and its round-trip delay time (in seconds). [1] The result, an amount of data measured in bits (or bytes), is equivalent to the maximum amount of data on the network circuit at any given time, i.e., data that has been transmitted but not yet acknowledged.
RTT is a measure of the amount of time taken for an entire message to be sent to a destination and for a reply to be sent back to the sender. The time to send the message to the destination in its entirety is known as the network latency, and thus RTT is twice the latency in the network plus a processing delay at the destination. The other ...
Based on Bill Dally's analysis of latency, average-case throughput, and hot-spot throughput of m-ary n-cube networks [2] for various m, it can be observed that low-dimensional networks, in comparison to high-dimensional networks (e.g., binary n-cubes) with the same bisection bandwidth (e.g., tori), have reduced latency and higher hot-spot ...
In computer network research, network simulation is a technique whereby a software program replicates the behavior of a real network. This is achieved by calculating the interactions between the different network entities such as routers, switches, nodes, access points, links, etc. [1] Most simulators use discrete event simulation in which the modeling of systems in which state variables ...