enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Open-circuit test - Wikipedia

   en.wikipedia.org/wiki/Open-circuit_test

   Circuit diagram for open-circuit test. The open-circuit test, or no-load test, is one of the methods used in electrical engineering to determine the no-load impedance in the excitation branch of a transformer. The no load is represented by the open circuit, which is represented on the right side of the figure as the "hole" or incomplete part of ...

3. Single-line diagram - Wikipedia

   en.wikipedia.org/wiki/Single-line_diagram

   A typical one-line diagram with annotated power flows. Red boxes represent circuit breakers, grey lines represent three-phase bus and interconnecting conductors, the orange circle represents an electric generator, the green spiral is an inductor, and the three overlapping blue circles represent a double-wound transformer with a tertiary winding.

4. Mathematics of three-phase electric power - Wikipedia

   en.wikipedia.org/wiki/Mathematics_of_three-phase...

   With linear loads, the neutral only carries the current due to imbalance between the phases. Devices that utilize rectifier-capacitor front ends (such as switch-mode power supplies for computers, office equipment and the like) introduce third order harmonics.

5. Leading and lagging current - Wikipedia

   en.wikipedia.org/wiki/Leading_and_Lagging_Current

   Angle notation can easily describe leading and lagging current: . [1] In this equation, the value of theta is the important factor for leading and lagging current. As mentioned in the introduction above, leading or lagging current represents a time shift between the current and voltage sine curves, which is represented by the angle by which the curve is ahead or behind of where it would be ...

6. Spot network substation - Wikipedia

   en.wikipedia.org/wiki/Spot_Network_Substation

   The transformers are wired together on the secondary side. The system is arranged so that nearby transformers do not use the same feeder. In case of an issue with a feeder (or transformer) the load is fed by nearby transformers, so there is no interruption, although a voltage drop for said load may then be present.

7. Electrical load - Wikipedia

   en.wikipedia.org/wiki/Electrical_load

   An electrical load is an electrical component or portion of a circuit that consumes (active) electric power, [1] [2] such as electrical appliances and lights inside the home. The term may also refer to the power consumed by a circuit.

8. Split-phase electric power - Wikipedia

   en.wikipedia.org/wiki/Split-phase_electric_power

   Unlike a three-wire distribution system, the grounded neutral is not distributed to the loads; only line-to-line connections at 120 V are used. A balanced power system is used only for specialized distribution in audio and video production studios, sound and television broadcasting, and installations of sensitive scientific instruments.

9. Pre-charge - Wikipedia

   en.wikipedia.org/wiki/Pre-charge

   Upon completion of pre-charging, the pre-charge resistance is switched out of the power supply circuit and returns to a low impedance power source for normal mode. The high voltage loads are then powered up sequentially. The simplest inrush-current limiting system, used in many consumer electronics devices, is a NTC resistor.