enow.com Web Search

  1. Ads

    related to: masonry wall ties and anchors

Search results

  1. Results from the WOW.Com Content Network
  2. Anchor plate - Wikipedia

    en.wikipedia.org/wiki/Anchor_plate

    An anchor plate, floor plate [1] or wall washer is a large plate or washer connected to a tie rod or bolt. Anchor plates are used on exterior walls of masonry buildings, for structural reinforcement against lateral bowing. Anchor plates are made of cast iron, sometimes wrought iron or steel, and are often made in a decorative style. [2]

  3. Tie (cavity wall) - Wikipedia

    en.wikipedia.org/wiki/Tie_(cavity_wall)

    Ties would be selected by type of masonry, the cavity width, and so on. Typically, ties in a cavity wall are double triangular shape (like a bow), though, depending on the existence of another layer (e.g. insulation sheet) at the cavity, which fills the cavity partially, ties include retaining discs or rods. Cavity Wall Tie

  4. Barnstar - Wikipedia

    en.wikipedia.org/wiki/Barnstar

    These are made of cast iron and are used as anchor plates serving as the washers for tie rods. The anchor-rod-and-plate assembly serves to brace the masonry wall against tilting or lateral bowing. The anchor-rod-and-plate assembly serves to brace the masonry wall against tilting or lateral bowing.

  5. Tie rod - Wikipedia

    en.wikipedia.org/wiki/Tie_rod

    Tie rods are often used in steel structures, such as bridges, industrial buildings, tanks, [1] towers, and cranes. Sometimes tie rods are retrofitted to bowing or subsiding masonry walls (brick, block, stone, etc.) to keep them from succumbing to lateral forces. The ends of the rods are secured by anchor plates which may be visible from the ...

  6. Wall plug - Wikipedia

    en.wikipedia.org/wiki/Wall_plug

    Before commercial wall plugs, fixings were made to brick or masonry walls by first chiselling a groove into a soft mortar joint, hammering in a crude wooden plug and then attaching to the wooden plug. This was time consuming and required a large hole, thus more patching of the wall afterwards. It also limited the holes' location to the mortar ...

  7. Tieback (geotechnical) - Wikipedia

    en.wikipedia.org/wiki/Tieback_(geotechnical)

    Typically in the form of a horizontal wire or rod, or a helical anchor, a tieback is commonly used along with other retaining systems (e.g. soldier piles, sheet piles, secant and tangent walls) to provide additional stability to cantilevered retaining walls. [1]

  1. Ads

    related to: masonry wall ties and anchors