Search results
Results from the WOW.Com Content Network
RAM drive software allows part of a computer's RAM (memory) to be seen as if it were a disk drive, with volume name and, if supported by the operating system, drive letter. A RAM drive has much faster read and write access than a hard drive with rotating platters, and is volatile, being destroyed with its contents when a computer is shut down ...
This is an accepted version of this page This is the latest accepted revision, reviewed on 2 December 2024. Restoring the software of an electronic device to its original state For the Tilian Pearson album, see Factory Reset (album). A factory reset, also known as hard reset or master reset, is a software restore of an electronic device to its original system state by erasing all data ...
Also, while earlier versions of the technology only monitored hard drive activity for data that was retrieved by the operating system, this latest S.M.A.R.T. tests all data and all sectors of a drive by using "off-line data collection" to confirm the drive's health during periods of inactivity.
Nonvolatile BIOS memory refers to a small memory on PC motherboards that is used to store BIOS settings. It is traditionally called CMOS RAM because it uses a volatile, low-power complementary metal–oxide–semiconductor (CMOS) SRAM (such as the Motorola MC146818 [1] or similar) powered by a small battery when system and standby power is off. [2]
The most common data recovery scenarios involve an operating system failure, malfunction of a storage device, logical failure of storage devices, accidental damage or deletion, etc. (typically, on a single-drive, single-partition, single-OS system), in which case the ultimate goal is simply to copy all important files from the damaged media to another new drive.
Internally, the device uses an NVM Express (NVMe) SSD using quad-level cell (QLC) flash memory, providing lower performance than SSDs using triple-level cell (TLC) or 2-bit MLC flash. The drive is based on Crucial's P1 internal SSD, but with modifications to its firmware to optimize it for external storage rather than for an operating system ...
Out-of-band management also frequently provides the possibility to reset the remote system in this way. Many memory-capable digital circuits (flip-flops, registers, counters and so on) accept the reset signal that sets them to the pre-determined state. This signal is often applied after powering on but may also be applied under other circumstances.
Regardless of operating system, the drive can detect when the computer writes all zeros to a block, and de-allocate (trim) that block instead of recording the block of zeros. If reading a de-allocated block always returns zeros, this shortcut is transparent to the user, except for faster writing (and reading) of all-zero blocks, in addition to ...