Search results
Results from the WOW.Com Content Network
General Motors started with a regular-cab, short-box (6-foot (180 cm) bed) S-10 pickup, with a base-level trim package plus a half-tonneau cover. In place of a typical inline four cylinder or V-6 internal combustion engine, the Electric S-10 EV was equipped with an 85-kilowatt (114 hp) three-phase, liquid-cooled AC induction motor, based on GM's EV1 electric coupe.
The Chevrolet S-10 is a compact pickup truck produced by Chevrolet.It was the first domestically-built compact pickup of the big three American automakers. When it was first introduced as a "quarter-ton pickup" in 1981 for the 1982 model year, the GMC version was known as the S-15 and later renamed the GMC Sonoma.
The crankcase air outlet, where the PCV valve is located, is generally placed as far as possible from the crankcase breather. For example, the breather and outlet are frequently on opposite valve covers on a V engine, or on opposite ends of the valve cover on an inline engine. The PCV valve is often, but not always, placed at the valve cover ...
An idle air control actuator or idle air control valve (IAC actuator/valve) is a device commonly used in fuel-injected vehicles to control the engine's idling rotational speed . [1] In carburetted vehicles a similar device known as an idle speed control actuator is used.
1983–1990 Chevrolet S-10 Blazer 2-door 1985 Chevrolet S-10 Blazer 2-door, rear view. Base power was provided by GM's 2.0-liter OHV gasoline inline four-cylinder engine, producing up to 83 horsepower (62 kW). A 2.8-liter 110 hp (82 kW) V6 was offered as an option (coincidentally, this engine was also used in Jeep's competing Cherokee until 1987).
The early fuel evaporator is a device found in some internal combustion engines with carburetors.It can sometimes be referred to as an electronic fuel evaporator. The device on a car, commonly referred to as an EFE heater, is located between the throttle body of the carburetor and the intake manifold as a gasket and contains a resistance grid that heats the air/fuel mixture.
The pump's air intake is filtered by a rotating screen or the vehicle air filter to exclude dirt particles large enough to damage the system. Air is delivered under light pressure to the injection point(s). A check valve prevents exhaust forcing its way back through the air injection system, which would damage the pump and other components.
It debuted in 1994 on the Chevrolet S-10 and the GMC Sonoma pickup trucks. The Sonoma ZR2 was known as ZR2 High-Rider. In 1996 it was expanded to the two-door Chevrolet Blazer and later offered on the Chevrolet Tracker. The ZR2 package was gradually phased out with the S-Series pickup and SUV lines.