Search results
Results from the WOW.Com Content Network
The vent/rollover valve provides a method of controlled escape for gasoline vapors during the refueling process. It has a mechanism which closes the vent in the event the vehicle rolls over, to prevent spilling of VOCs or fuel in general. It also acts as a fill limiter. [8] [dead link ]
The early fuel evaporator is a device found in some internal combustion engines with carburetors.It can sometimes be referred to as an electronic fuel evaporator. The device on a car, commonly referred to as an EFE heater, is located between the throttle body of the carburetor and the intake manifold as a gasket and contains a resistance grid that heats the air/fuel mixture.
The Dodge Nitro is a compact SUV [3] [4] manufactured and marketed by Dodge for model years 2007–2012 across a single generation — as a close variant of the second-generation Jeep Liberty. Both vehicles use a composite unitized construction integrating the body structure with full-length frame rails.
The 2.2l S10/Sonoma had the starter located in the same position as front wheel drive cars. A rear wheel drive bellhousing is displayed at right, and the integrated front wheel drive bellhousing is displayed at the lower right (in this case, as a part of the GM 6T70 Transmission).
General Motors started with a regular-cab, short-box (6-foot (180 cm) bed) S-10 pickup, with a base-level trim package plus a half-tonneau cover. In place of a typical inline four cylinder or V-6 internal combustion engine, the Electric S-10 EV was equipped with an 85-kilowatt (114 hp) three-phase, liquid-cooled AC induction motor, based on GM's EV1 electric coupe.
The 3.5 L engine was expanded to 4.0 L; 241.2 cu in (3,952 cc) for the 2007 Dodge Nitro and Chrysler Pacifica. Like its family members, this is a SOHC engine and was built in Trenton, Michigan . DaimlerChrysler reportedly spent $155 million to expand the Trenton plant to manufacture this engine.
The Chevrolet S-10 is a compact pickup truck produced by Chevrolet.It was the first domestically-built compact pickup of the big three American automakers. When it was first introduced as a "quarter-ton pickup" in 1981 for the 1982 model year, the GMC version was known as the S-15 and later renamed the GMC Sonoma.
Pushrods are long, slender metal rods that are used in overhead valve engines to transfer motion from the camshaft (located in the engine block) to the valves (located in the cylinder head). The bottom end of a pushrod is fitted with a lifter , upon which the camshaft makes contact.