Search results
Results from the WOW.Com Content Network
As the target temperature of the refrigerator approaches ambient temperature, without exceeding it, the refrigeration capacity increases thus increasing the refrigerator's COP. The SI unit is watt (W). Another unit common in non-metric regions or sectors is the ton of refrigeration, which describes the amount of water at freezing temperature ...
For reference, about 10,000 100-watt lightbulbs or 5,000 computer systems would be needed to draw 1 MW. Also, 1 MW is approximately 1360 horsepower . Modern high-power diesel-electric locomotives typically have a peak power of 3–5 MW, while a typical modern nuclear power plant produces on the order of 500–2000 MW peak output.
The measured capacity of refrigeration is often dimensioned in the unit of kW or BTU/h. Domestic and commercial refrigerators may be rated in kJ/s, or Btu/h of cooling. For commercial and industrial refrigeration systems, the kilowatt (kW) is the basic unit of refrigeration, except in North America, where both ton of refrigeration and BTU/h are ...
The watt (symbol: W) is the unit of power or radiant flux in the International System of Units (SI), equal to 1 joule per second or 1 kg⋅m 2 ⋅s −3. [ 1 ] [ 2 ] [ 3 ] It is used to quantify the rate of energy transfer .
A representative pressure–volume diagram for a refrigeration cycle. Vapour-compression refrigeration or vapor-compression refrigeration system (VCRS), [1] in which the refrigerant undergoes phase changes, is one of the many refrigeration cycles and is the most widely used method for air conditioning of buildings and automobiles.
The notation kW/h for the kilowatt-hour is incorrect, as it denotes kilowatt per hour. The hour is a unit of time listed among the non-SI units accepted by the International Bureau of Weights and Measures for use with the SI. [6] An electric heater consuming 1,000 watts (1 kilowatt) operating for one hour uses one kilowatt-hour of energy.
The volt-ampere (SI symbol: VA, [1] sometimes V⋅A or V A) is the unit of measurement for apparent power in an electrical circuit. It is the product of the root mean square voltage (in volts) and the root mean square current (in amperes). [2] Volt-amperes are usually used for analyzing alternating current (AC) circuits.
Digital electronic instruments measure many parameters and can be used where a wattmeter is needed: volts, current in amperes, apparent instantaneous power, actual power, power factor, energy in [k]W·h over a period of time, and cost of electricity consumed.