Search results
Results from the WOW.Com Content Network
The Armstrong oscillator [1] (also known as the Meissner oscillator [2]) is an electronic oscillator circuit which uses an inductor and capacitor to generate an oscillation. The Meissner patent from 1913 describes a device for generating electrical vibrations, a radio transmitter used for on–off keying. Edwin Armstrong presented in 1915 some ...
English: Diagram of an Armstrong oscillator circuit using a FET as the active device. The Armstrong oscillator, invented by Edwin Armstrong in 1913, was one of the earliest oscillator circuits. It is an LC oscillator, in which the frequency is determined by a tuned circuit consisting of the inductor L1 and capacitor C.
For AM reception, the gain of the loop is adjusted so it is just below the level required for oscillation (a loop gain of just less than one). The result of this is to greatly increase the gain of the amplifier at the bandpass frequency (resonant frequency), while not increasing it at other frequencies.
Simple relaxation oscillator made by feeding back an inverting Schmitt trigger's output voltage through a RC network to its input.. An electronic oscillator is an electronic circuit that produces a periodic, oscillating or alternating current (AC) signal, usually a sine wave, square wave or a triangle wave, [1] [2] [3] powered by a direct current (DC) source.
In the Armstrong method, the audio signal and the radio frequency carrier signal are applied to the balanced modulator to generate a double sideband suppressed carrier signal. The phase of this output signal is then shifted 90 degrees with respect to the original carrier. The balanced modulator output can either lead or lag the carrier's phase.
All these early technologies were superseded by the vacuum tube feedback electronic oscillator, invented in 1912 by Edwin Armstrong and Alexander Meissner, which used the triode vacuum tube invented in 1906 by Lee de Forest. [1] Vacuum tube oscillators were a far cheaper source of continuous waves, and could be easily modulated to carry sound ...
Main page; Contents; Current events; Random article; About Wikipedia; Contact us; Help; Learn to edit; Community portal; Recent changes; Upload file
In 1914 Edwin Armstrong described the audion receiver. [1] In 1915 he described some regenerative audion receivers. [2] Fig.3 shows the audion, Fig. 8 the tickler coil regenerative audion and Fig. 9 the Miller effect regenerative audion. All circuits use one tube for RF amplification, RF demodulation and audio amplification.