enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Nut (hardware) - Wikipedia

   en.wikipedia.org/wiki/Nut_(hardware)

   The cage has two wings that when compressed allow the cage to be inserted into the square holes Clip-on nut: J-nut or U-nut, sheet metal nut, speed nut (ambiguously) Designed to be clipped to sheet metal Coupling nut: Extension nut A threaded fastener for joining two male threads, most commonly a threaded rod,[1][2] but also pipes Flange nut ...

3. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   Although flange fittings are bulky, they perform well in demanding applications such as large water supply networks and hydroelectric systems. Flanges are rated at 150, 300, 400, 600, 900, 1500, and 2500 psi; or 10, 15, 25, 40, 64, 100, and 150 bars of pressure. Various types of flanges are available, depending on construction.

4. Concrete mixer - Wikipedia

   en.wikipedia.org/wiki/Concrete_mixer

   The mixer already exhibited the still common basic construction with a tiltable conical drum (as double cone at that time) with blades. On February 9, 1904, the first portable concrete mixer was patented by Richard Bodlaender, an inventor from Breslau, Germany. [2] This concrete mixer was horse-drawn and called 'Mortar Mixer'.

5. Split beam nut - Wikipedia

   en.wikipedia.org/wiki/Split_beam_nut

   A split beam nut, also known as a split hex nut [1] or slotted beam nut, [2] is a locknut with slots cut in the top that separate the outside end into two [3] or more sections that are bent slightly inward, making the thread diameter undersized in the slotted portion.

6. Flange nut - Wikipedia

   en.wikipedia.org/wiki/Flange_nut

   A self-aligning nut, also known as a spherical nut [2] or leveling nut, is a type of nut used in applications where the fastener is not perpendicular to the surface to which the nut anchors. A flange nut is used inside a specially shaped dished-out washer. The device is commonly used in the aerospace industry.

7. List of screw and bolt types - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_and_bolt_types

   They may either have a Phillips flat head or a slotted hex washer head. Nominal (thread) sizes range from 0.1875 to 0.375 in (4.763 to 9.525 mm) and lengths from 1.25 to 5 in (32 to 127 mm). Typically an installer uses a hammer drill to make a pilot hole for each concrete screw and a powered impact driver to drive the screw. The drill hole ...

8. Bolt (fastener) - Wikipedia

   en.wikipedia.org/wiki/Bolt_(fastener)

   Allow nuts to be attached to what is really a screw. Hex bolt - Bolt with a hexagonal head and threaded shank. Section immediately under head may be unthreaded for fastening thicker materials. J bolt - Bolt shaped like the letter J, used for tie downs. Only the straight section is threaded for a nut.

9. Ready-mix concrete - Wikipedia

   en.wikipedia.org/wiki/Ready-mix_concrete

   There are two types with the first being the barrel truck or in–transit mixers. This type of truck delivers concrete in a plastic state to the site. [2] The second is the volumetric concrete mixer. This delivers the ready mix in a dry state and then mixes the concrete on site.