enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Microphone connector - Wikipedia

   en.wikipedia.org/wiki/Microphone_connector

   Two pins are used for the mono headphone signal and two pins for the unbalanced microphone signal. The 4-pin XLR connector is also commonly used on amateur radio microphones, but transferring unbalanced audio instead, and using the 4th pin (with the common ground) for a push-to-talk (PTT) circuit activated by a button on the microphone.

3. XLR connector - Wikipedia

   en.wikipedia.org/wiki/XLR_connector

   XLR3 cable connectors female (left) and male. The XLR connector is a type of electrical connector primarily used in professional audio, video, and stage lighting equipment. XLR connectors are cylindrical, with three to seven connector pins, and are often employed for analog balanced audio interconnections, AES3 digital audio, portable intercom, DMX512 lighting control, and for low-voltage ...

4. Audio multicore cable - Wikipedia

   en.wikipedia.org/wiki/Audio_multicore_cable

   Typical live use of a multicore (thick cable on stage) Multicores usually create a link between the stage and sound desk, or live room and control room.When used in sound reinforcement, the multicore cable runs from the stage box or microphone splitter to the front-of-house sound desk, where it connects to a mixing console. [2]

5. Phone connector (audio) - Wikipedia

   en.wikipedia.org/wiki/Phone_connector_(audio)

   They often appeared next to a 3.5 mm microphone jack for a remote control on-off switch on early portable tape recorders; the microphone provided with such machines had the on-off switch and used a two-pronged connector with both the 3.5 and 2.5 mm plugs. They were also used for low-voltage DC power input from wall adapters.

6. RCA connector - Wikipedia

   en.wikipedia.org/wiki/RCA_connector

   Varying cable quality means that a cheap line-level audio cable might not successfully transfer component video. For digital audio, as long as a connection is successfully made using the cables the sound will remain faithful to the original signal because a digital signal can only be fully received or not received at all. Cables should meet the ...

7. Balanced audio - Wikipedia

   en.wikipedia.org/wiki/Balanced_audio

   Balanced connections typically use shielded twisted-pair cable and three-conductor connectors. The connectors are usually three-pin XLR or 1 ⁄ 4 inch (6.35 mm) TRS phone connectors. When used in this manner, each cable carries one channel, therefore stereo audio (for example) would require two of them.