Search results
Results from the WOW.Com Content Network
Watt's linkage automobile suspension Watt's linkage train suspension. Watt's linkage is used in the rear axle of some car suspensions as an improvement over the Panhard rod, which was designed in the early twentieth century. Both methods are intended to prevent relative sideways motion between the axle and body of the car.
A Suntour Sprint rear derailleur A front derailleur manufactured by Suntour a pair of Suntour road brakes. In 1964, Suntour invented the slant-parallelogram rear derailleur. The parallelogram rear derailleur had gained prominence after Campagnolo's introduction of the "Gran Sport" in 1949, [7] [8] and the slant-parallelogram was an improvement of it that allowed the derailleur to maintain a ...
De Dion suspension characteristics: Camber change on one-sided bumps, none on rebound. The de Dion tube is shown in blue. The differential (yellow) is connected directly to the chassis (orange). Universal joints are shown in green. De Dion rear axle. A de Dion axle is a form of non-independent automobile suspension.
However, motorcycles with rear suspension were offered to the public before World War I. Notable among these are the 1909 A.S.L. which had both front and rear pneumatic suspension, [11] the 1913 Indian Single with a swingarm suspended from a leaf spring and the 1913 Pope with wheels supported on a pair of plungers which were each suspended by a ...
A swing axle is a simple type of independent suspension designed and patented by Edmund Rumpler in 1903 for the rear axle of rear wheel drive vehicles. This was a revolutionary invention in automotive suspension, allowing driven (powered) wheels to follow uneven road surfaces independently, thus enabling the vehicle's wheels to maintain better ...
The spider gears mount on the pinion cross shaft which rests in angled cutouts forming cammed ramps. The cammed ramps are not necessarily symmetrical. If the ramps are symmetrical, the LSD is 2 way. If they are saw toothed (i.e. one side of the ramp is vertical), the LSD is 1 way. If both sides are sloped, but are asymmetric, the LSD is 1.5 way.
Two examples are the Z28 and Z71. In the 1980s you could order a Z28 Camaro with a 2.5 liter engine, although this was rare. RPO Z71 was an off-road suspension for trucks that is not related to the drivetrain. It became notable enough to be promoted to a package name, even applied as a logo sticker onto the rear quarter body panel.
As such, push-rod suspension systems allow for much greater high-speed stability, much lower levels of body-roll, and a much lower centre of gravity for the vehicle. [7] For pull-rod suspension systems, the only difference is the orientation of the rocker arms. In a push-rod system, the rocker arms are placed at the highest point in the assembly.