Search results
Results from the WOW.Com Content Network
The CSAFE specification describes the physical wiring scheme as well as the format of the data frames. The CSAFE protocol is designed to work in a master/slave fashion. A special I/O jack on the exercise equipment accepts a normal 8P8C (RJ-45) plug (although the wiring scheme has no relation to ethernet) wired to a normal RS-232 cable.
M1-A EVC cable. The VESA Enhanced Video Connector (EVC) is a VESA standard that was intended to reduce the number of cables around a computer by incorporating video, audio, FireWire and USB into a single cable system, terminating in a 35-pin Molex MicroCross connector. The intent was to make the monitor the central point of connection.
25-pair telco cable pinout [ edit ] A common application of the 25-pair color code is the cabling for the Registered Jack interface RJ21, which uses a female 50-pin miniature ribbon connector , as shown in the following table.
In the male connector, this pin numbering corresponds with the cable's wire-and-solder side. The Video Graphics Array ( VGA ) connector is a standard connector used for computer video output. Originating with the 1987 IBM PS/2 and its VGA graphics system, the 15-pin connector went on to become ubiquitous on PCs, [ 1 ] as well as many monitors ...
A cable terminated according to T568A on one end and T568B on the other is a crossover cable when used with the earlier twisted-pair Ethernet standards that use only two of the pairs because the pairs used happen to be pairs 2 and 3, the same pairs on which T568A and T568B differ. Crossover cables are occasionally needed for 10BASE-T and ...
The standard was withdrawn without a replacement in November 1998, but remains in widespread use by cable manufacturers. The isolations of the several wires in a cable are either solidly colored in one color, or striped lengthwise in two colors. Use of the three-colored wires numbered 45 and up is rare.
The connector on the Amiga 1000 uses crossover wiring, similar to a telephone handset. The connector wiring on the Apple computers, however, requires a polarized straight-through pinout. Using a telephone handset cable instead of the supplied cable could short out the +5 volt DC supply and damage the Apple computer or the keyboard. [12]
A cable could have 5.25-inch style connectors, 3.5-inch style connectors, or a combination. After IBM introduced the "twist" to floppy cables, and when both 5.25-inch and 3.5-inch drives were in common use, many cables had four connectors: one of each type before the twist, and one of each type after the twist.