Search results
Results from the WOW.Com Content Network
Automatic test system switching test equipment allows for high-speed testing of a device or devices in a test situation, where strict sequences and combinations of switching must be observed. By automating the process in this way, the possibility of test errors and inaccuracies is minimized, and only systematic errors would generally be ...
The DMS-100 is a member of the Digital Multiplex System (DMS) product line of telephone exchange switches manufactured by Northern Telecom. Designed during the 1970s and released in 1979, it can control 100,000 telephone lines. [1] The purpose of the DMS-100 Switch is to provide local service and connections to the PSTN public
EMS-1 (The ITEC Electronic Modular Switch is an electronic direct control switching system. The modules are combined to form a complete switch or any of the modules can be added to your present Step-by-Step Systems.) EMS-2 (The EMS-2 RURAL SWITCH is a stored program control analog switch designed to be cost-effective in small exchanges.
The first Class 5 switch, the DMS-10, began service on 21 October 1977 in Fort White, Florida and the first toll switch (Class 4), the DMS-200, entered service in 1979 in Ottawa. The DMS-10 was the first commercially successful Class 5 digital switch in the North American market and had a profound impact on the industry.
First, the switch matrix receives the data bus signals, then provides the proper switching and signal conditioning for the signals before feeding the signals to the test and measurement instruments. This custom switch matrix would employ 14 EM switches and a number of different signal conditioners including: power splitters, amplifiers, mixers ...
Each operator sat in front of a vertical panel containing banks of ¼-inch tip-ring-sleeve (3-conductor) jacks, each of which was the local termination of a subscriber's telephone line. In front of the jack panel lay a horizontal panel containing two rows of patch cords, each pair connected to a cord circuit.
Some manufacturers released some 4000-series equivalent CMOS circuits with a 74 prefix, for example, the 74HC4066 [2] was a replacement for the 4066 with slightly different electrical characteristics (different power-supply voltage ratings, higher frequency capabilities, lower "on" resistances in analog switches, etc.).
A common form of in-circuit testing uses a bed-of-nails tester.This is a fixture that uses an array of spring-loaded pins known as "pogo pins". When a printed circuit board is aligned with and pressed down onto the bed-of-nails tester, the pins make electrical contact with locations on the circuit board, allowing them to be used as test points for in-circuit testing.