Search results
Results from the WOW.Com Content Network
An oedometer test is a kind of geotechnical investigation performed in geotechnical engineering that measures a soil's consolidation properties. Oedometer tests are performed by applying different loads to a soil sample and measuring the deformation response.
Deformation monitoring is a major component of logging measured values that may be used for further computation, deformation analysis, predictive maintenance, and alarming. [ 1 ] Deformation monitoring is primarily associated with the field of applied surveying but may also be relevant to civil engineering, mechanical engineering, construction ...
The strength of the advance core medium and its sensitivity to deformation determine the stability and the deformation characteristics of the tunnel. Taking measures to improve the stiffness of the advance core medium can relieve the deformation reaction of the tunnel face and cavity. [6] ADECO-RS are broadly based on the following principles:
In the initial stage of deformation, the volumetric strain decreases as the shear strain increases. But as the stress approaches its peak value, the volumetric strain starts to increase. After some more shear, the soil sample has a larger volume than when the test was started. The amount of dilation depends strongly on the initial density of ...
The test is normally run at several moisture contents, and the moisture content which requires 25 blows to close the groove is interpolated from the test results. The liquid limit test is defined by ASTM standard test method D 4318. [4] The test method also allows running the test at one moisture content where 20 to 30 blows are required to ...
The rate of axial deformation is kept constant, i.e., strain is controlled. The test allows the sample and the pore pressures to fully consolidate (i.e., adjust) to the surrounding stresses. The test may take a long time to allow the sample to adjust, in particular low permeability samples need a long time to drain and adjust strain to stress ...
The cone penetration or cone penetrometer test (CPT) is a method used to determine the geotechnical engineering properties of soils and delineating soil stratigraphy. It was initially developed in the 1950s at the Dutch Laboratory for Soil Mechanics in Delft to investigate soft soils. Based on this history it has also been called the "Dutch ...
The R-Value test [1] measures the response of a compacted sample of soil or aggregate to a vertically applied pressure under specific conditions. This test is used by Caltrans for pavement design, replacing the California bearing ratio test. Many other agencies have adopted the California pavement design method, and specify R-Value testing for ...