Search results
Results from the WOW.Com Content Network
The most significant difference between the two is that 6N2P has its two filament elements connected in parallel, unlike the series filament connection of the 12AX7, and it is thus only possible to operate it from a 6.3 volt, 340 mA filament supply (whereas a 12AX7 may be operated from either 6.3 or 12.6 volts, at 300 mA or 150 mA, respectively.)
A compressor map is a chart which shows the performance of a turbomachinery compressor. This type of compressor is used in gas turbine engines, for supercharging reciprocating engines and for industrial processes, where it is known as a dynamic compressor. A map is created from compressor rig test results or predicted by a special computer program.
If a variable speed drive compressor operates continuously at full speed, the switching losses of the frequency converter result in a lower energy efficiency than an otherwise identically sized fixed speed compressor. Where demand remains constant within 5–15% of the total free air delivery flow rate, dual-control compressors configured in a ...
12AX7 (also known as ECC83 [1]) is a miniature dual-triode vacuum tube with high voltage gain. Developed around 1946 by RCA engineers [ 2 ] in Camden, New Jersey , under developmental number A-4522, it was released for public sale under the 12AX7 identifier on September 15, 1947.
"Frost-Free" refrigerator/freezer units usually use a heating element to defrost their evaporators, a pan to collect and evaporate water from the frost that melts from the cold plate and/or evaporator coil, a timer which turns off the compressor and turns on the defrost element usually from once to 4 times a day for periods usually ranging from ...
In air conditioning, an inverter compressor is a compressor that is operated with an inverter. In the hermetic type, it can either be a scroll or reciprocating compressor . This type of compressor uses a drive to control the compressor motor speed to modulate cooling capacity.
The compression ratio in a MVR unit does not usually exceed 1.8. At a compression ratio of 1.8, if the evaporation is performed at atmospheric pressure (0.101 MPa), the condensation pressure after compression will be 0.101 x 1.8 = 0.1818 [MPa]. At this pressure, the condensation temperature of the water vapor at the heat exchanger will be 390 K.
Principal view of the pumping action of a twin-screw pump with a six-lobe female screw and a five-lobe male screw. A compressor (as opposed to a pump) would be shaped the same way, except that the shape of the lobes would change along the length of the screw, so that the volume of the trapped pockets would get squeezed smaller as they get closer to the exhaust port.