Search results
Results from the WOW.Com Content Network
The taper rate for all NPT threads is 1 inch of diameter in 16 inches of length (3 ⁄ 4 inch per foot or 62.5 millimeters per meter) measured by the change of diameter (of the pipe thread) over distance of thread.
The Metric Act of 1866, also known as the Kasson Act, is a piece of United States legislation that legally protected use of the metric system in commerce from lawsuit, and provided an official conversion table from United States customary units. [1]
The legislation required most federal agencies to use the metric system in their procurement, grants, and other business-related activities by the end of 1992. [26] While not mandating metric use in the private sector, the federal government has sought to serve as a catalyst in the metric conversion of the country's trade, industry, and commerce.
ANSI B1.20.3-1976 (R2013) Dryseal Pipe Threads (Inch) Pipe Thread Form ASME B1.20.7-1991 (R2013) Hose Coupling Screw Threads - Inch: Pipe Thread Form ASME B1.21M-1997 (R2013) Metric Screw Threads - MJ Profile: V Thread Form BS 84: Tables of BS Whitworth, BS Fine and BS Pipe Threads: V Thread Form (55°) 1 ⁄ 4 ″-20 BSW ISO 68-1:1998
The U.S. government passed the Metric Conversion Act of 1975, which made the metric system "the preferred system of weights and measures for U.S. trade and commerce". The legislation states that the federal government has a responsibility to assist industry as it voluntarily converts to the metric system, i.e., metrification. This is most ...
The major diameter still extends to within 1 / 8 H of the theoretical sharp V, but the total depth of the thread is reduced 4% from 5 / 8 H = 5 / 8 cos(30°) P ≈ 0.541P to 0.52P. [5] This increases the amount of the theoretical sharp V which is cut off at the minor diameter by 10% from 0.25H to 7 / 8 − 0. ...
The Metric Conversion Act of 1975 is an Act of Congress that was signed into law by U.S. President Gerald Ford on December 23, 1975. [1] It declared the metric system "the preferred system of weights and measures for United States trade and commerce", but permitted the use of United States customary units in all activities.
The metric standard used the same thread geometry as the USS standard but differed in that the dimensions and pitch were based on metric units. In 1906, the A.L.A.M developed what would be the SAE thread standard for threaded fasteners based on the USS standard but with a finer thread pitch.