Search results
Results from the WOW.Com Content Network
This is a unique-looking barrel connector, apparently intended for providing a DC output jack (most DC jacks are used for power input).. Possibly available in multiple voltage ranges, the one for voltage classification 2 (3.15 to 6.3 V) has an outside diameter of 4.75 mm and a protruding pin of 2.5 mm diameter.
The coupling design is specified by CAN/ULC-S551-13 (25 mm and 38 mm forged couplers), CAN/ULC-S558-13 (25 mm and 38 mm non-forged couplers), and ULC/CAN-S574 (64 mm forged couplers), as well as USFDA 5100-192 (US Forest Service) and available for use with 19 mm, 25 mm, 38 mm, and 64 mm hose sizes.
m ft (m foot) decimetre: dm dm US spelling: decimeter: 1.0 dm (3.9 in) centimetre: cm cm US spelling: centimeter: 1.0 cm (0.39 in) cm in; millimetre: mm mm US spelling: millimeter: 1.0 mm (0.039 in) mm in; micrometre: μm (um, micrometre) μm US spelling: micrometer: 1.0 μm (3.9 × 10 −5 in) nanometre: nm nm US spelling: nanometer: 1.0 nm (3 ...
They were a single ⌀3.2 mm negative pin and a single ⌀4.0 mm positive pin spaced 13.0 mm apart. PP11: 4.5 + 4.5: H: 91.3 L: 65.1 W: 52.4 This battery contained two independent 4.5 V batteries, and had a four-pin connector. 9 V with a center tap was available by wiring in series. There were two ⌀3.2 mm negative pins spaced 9.5 mm apart and ...
Although the nominal voltage of a 12 V lead acid battery is 12 V DC, when the engine is running the car's battery charging system will bring the system voltage to 13.8 V DC or higher. [10] The possible range of battery voltages from 11–15 V DC must be taken into account by devices attached to the cigar lighter socket.
A metric ISO screw thread is designated by the letter M followed by the value of the nominal diameter D (the maximum thread diameter) and the pitch P, both expressed in millimetres and separated by a dash or sometimes the multiplication sign, × (e.g. M8-1.25 or M8×1.25). If the pitch is the normally used "coarse" pitch listed in ISO 261 or ...
After the two common 5.5 mm OD (Outer Diameter) plugs, the next-most common size is 3.5 mm OD with a 1.3 mm ID (Inner Diameter), usually about 9.5 mm in length, although both longer and shorter versions also exist. These 3.5 mm OD plugs are normally used for lower voltages and currents.
Mosaic Engineering Luma / Luma II (digital backs with a 36 mm × 24 mm (1.42 in × 0.94 in) sensor; resolution is 3072×2048 (Luma) or 4008×2672 (Luma II); requires host computer) [13] [14] [15] Film-Holder Adaptors for Hasselblad 6×6, Contax 645 and Mamiya 645 backs (other makers digital backs can also be mounted to Fuji GX680 by ...