Search results
Results from the WOW.Com Content Network
Under-cabinet light – mounted below kitchen wall cabinets. Display Case or Showcase light – shows merchandise on display within an enclosed case such as jewelry, grocery stores, and chain stores. Ceiling fan – may sometimes have a light, often referred to as a light kit mounted to it. Ceiling fans with built-in lights may eliminate the ...
Engine bay lighting; Fog light (also called foglamp) Spotlight; Headlight (also called headlamp) Headlight motor; Interior light and lamp, Center dome, Vanity-Sun visor and rear side, Floor and Door-front, back, Boot lamp or Trunk lamp; License plate lamp (also called number plate lamp or registration plate lamp) Side lighting
The suffix after the G indicates the pin spread; the G dates to the use of Glass for the original bulbs. GU usually also indicates that the lamp provides a mechanism for physical support by the luminaire: in some cases, each pin has a short section of larger diameter at the end (sometimes described as a "peg" rather than a "pin" [2]); the socket allows the bulb to lock into place by twisting ...
Direction indicator lights [23] or turn signals, [11] informally known as directional signals, directionals, blinkers, or indicators, are blinking lights mounted near the left and right front and rear corners of a vehicle, and sometimes on the sides or on the side mirrors of a vehicle (where they are called repeaters [50]).
A lightbulb socket, lightbulb holder, light socket, lamp socket or lamp holder is a device which mechanically supports and provides electrical connections for a compatible electric lamp base. [1] Sockets allow lamps to be safely and conveniently replaced (re-lamping).
The gusset plate is welded to a beam, and then two or three columns, beams, or truss chord are connected to the other side of the gusset plate through bolts or rivets or welds. [3] A uniform force bracing connection connects a beam, column, and one other member. The gusset plate is bolted to the column and welded to the beam.
The dimension of a wide-flange I-beam. In the United States, steel I-beams are commonly specified using the depth and weight of the beam. For example, a "W10x22" beam is approximately 10 in (254 mm) in depth with a nominal height of the I-beam from the outer face of one flange to the outer face of the other flange, and weighs 22 lb/ft (33 kg/m).
Stresses on the flanges near the centre of the span are greater than near the end of the span, so the top and bottom flange plates are frequently reinforced in the middle portion of the span. Vertical stiffeners prevent the web plate from buckling under shear stresses. These are typically uniformly spaced along the girder with additional ...