Search results
Results from the WOW.Com Content Network
The image would be a very low quality image (72ppi) if printed at about 28.5 inches wide, but a very good quality (300ppi) image if printed at about 7 inches wide. The number of photodiodes in a color digital camera image sensor is often a multiple of the number of pixels in the image it produces, because information from an array of color ...
The wide version of SVGA is known as WSVGA (Wide Super VGA or Wide SVGA), [97] featured on Ultra-Mobile PCs, netbooks, and tablet computers. The resolution is either 1024 × 576 (aspect ratio 16:9) [citation needed] or 1024 × 600 (128:75) with screen sizes normally ranging from 7 to 10 inches. It has full XGA width of 1024 pixels.
The display aspect ratio (DAR) is calculated from the physical width and height of a display, measured each in inch or cm (Display size). The pixel aspect ratio (PAR) is calculated from the width and height of one pixel. The storage aspect ratio (SAR) is calculated from the numbers of pixels in width and height stated in the display resolution.
A good example of this a 4×6 print (6 inch wide by 4 inch tall landscape) perfectly matches the 3:2 aspect ratio of a DSLR/35 mm, since 6/2=3 and 4/2=2. For analog projection of photographic slides, projector and screen use a 1:1 aspect ratio, supporting horizontal and vertical orientation equally well.
4:3 (non-square pixels) 1–4 bpp typical, 2 or 3 bpp common. WQVGA: Wide Quarter Video Graphics Array Effectively 1/16 the total resolution (1/4 in each dimension) of "Full HD", but with the height aligned to an 8-pixel "macroblock" boundary. Common in small-screen video applications, including portable DVD players and the Sony PSP. 480×272 ...
Pixel aspect ratio 1:1 Pixel aspect ratio 2:1. A Pixel aspect ratio (often abbreviated PAR) is a mathematical ratio that describes how the width of a pixel in a digital image compared to the height of that pixel. Most digital imaging systems display an image as a grid of tiny, square pixels.
Sizes are often expressed as a fraction of an inch, with a one in the numerator, and a decimal number in the denominator. For example, 1/2.5 converts to 2/5 as a simple fraction, or 0.4 as a decimal number. This "inch" system gives a result approximately 1.5 times the length of the diagonal of the sensor.
The letter M, on the left in Perpetua and on the right in Calisto, inside squares of one em on each side.The M in Perpetua does not match the point size of the em.. In some older texts, but not all, the em is defined, or said to have been defined, as the width of the capital 'M' in the current typeface and point size. [3]