Search results
Results from the WOW.Com Content Network
However, this gain is not without a downside. Large packets occupy a link for more time than a smaller packet, causing greater delays to subsequent packets, and increasing network delay and delay variation. For example, a 1500-byte packet, the largest allowed by Ethernet at the network layer, ties up a 14.4k modem for about one second.
This may require breaking large protocol data units or long data streams into smaller chunks called "segments", since the network layer imposes a maximum packet size called the maximum transmission unit (MTU), which depends on the maximum packet size imposed by all data link layers on the network path between the two hosts. The amount of data ...
The ITU-T G.hn standard, which provides a way to create a high-speed (up to 1 Gigabit/s) Local area network using existing home wiring (power lines, phone lines and coaxial cables), is an example of a protocol that employs packet aggregation to increase efficiency.
The Layer 4: transport layer PDU is the segment or the datagram. The Layer 3: network layer PDU is the packet. The Layer 2: data link layer PDU is the frame. The Layer 1: physical layer PDU is the bit or, more generally, symbol. Given a context pertaining to a specific OSI layer, PDU is sometimes used as a synonym for its representation at that ...
Reliable transmission of data segments between points on a network, including segmentation, acknowledgement and multiplexing: Media layers 3 Network: Packet: Structuring and managing a multi-node network, including addressing, routing and traffic control: 2 Data link: Frame: Transmission of data frames between two nodes connected by a physical ...
A different slave becomes active if, and only if, the active slave fails. The single logical bonded interface's MAC address is externally visible on only one NIC (port) to simplify forwarding in the network switch. This mode provides fault tolerance. XOR (balance-xor) Transmit network packets based on a hash of the packet's source and destination.
In the seven-layer OSI model of computer networking, packet strictly refers to a protocol data unit at layer 3, the network layer. [2] A data unit at layer 2, the data link layer , is a frame . In layer 4, the transport layer , the data units are segments and datagrams .
Every network has a width w, and a transmission rate f, which decide the bandwidth of a network as b = w*f. The amount of data transferred in a single cycle is called a physical unit or phit. As is observable, the width of a network is also equal to the phit size. Hence the bandwidth of the network can also be defined in terms of phit/sec.