Search results
Results from the WOW.Com Content Network
A limitation of Port Aggregation Protocol is that all the physical ports in the aggregation group must reside on the same switch. Cisco's 6500 and the 4500E platforms, remove this limitation using Virtual Switching System (VSS), [1] which allows port channels to be split between two chassis. PAgP is not supported in Cisco Nexus Switches.
The port will not send out DTP frames or be affected by any incoming DTP frames. If you want to set a trunk between two switches when DTP is disabled, you must manually configure trunking using the (switchport mode trunk) command on both sides. The configured switch port mode setting is referred to as the port's trunking administrative mode.
To do this, VTP carries VLAN information to all the switches in a VTP domain. VTP advertisements can be sent over 802.1Q, and ISL trunks. VTP is available on most of the Cisco Catalyst Family products. Using VTP, each Catalyst Family Switch advertises the following on its trunk ports: Management domain; Configuration revision number
Example scenario: a switch with VLAN 100, converted into a Private VLAN with one P-Port, two I-Ports in Isolated VLAN 101 (Secondary) and two community VLANs 102 and 103 (Secondary), with 2 ports in each. The switch has one uplink port (trunk), connected to another switch. The diagram shows this configuration graphically.
EtherChannel between a switch and a server. EtherChannel is a port link aggregation technology or port-channel architecture used primarily on Cisco switches.It allows grouping of several physical Ethernet links to create one logical Ethernet link for the purpose of providing fault-tolerance and high-speed links between switches, routers and servers.
Provide Layer 3 IP connectivity to the switch. Support bridging configurations and routing protocol. Access Layer - 'Routed Access' Configuration (in lieu of Spanning Tree) SVIs advantages include: Much faster than router-on-a-stick, because everything is hardware-switched and routed. No need for external links from the switch to the router for ...
Cisco's IOS software maintains one IDB for each hardware interface in a particular Cisco switch or router and one IDB for each subinterface. The number of IDBs present in a system varies with the Cisco hardware platform type. Physical and logical interfaces on the switch will be referenced with either expanded or abbreviated port description names.
The alternative is to have different logical switches, but then one of the used links will have to be blocked to ensure a loop-free topology (which can partially be overcome by using Multiple Spanning Tree or Cisco's proprietary per VLAN spanning tree. Spanning Tree Protocol is relatively slow in convergence, which can result in periods that ...