Ad
related to: datasheet of zener diode in parallel line analysis system- Triac(704)
Search Description : 'TRIAC'
Total: 1/103 Pages
- Rectifier(18,655)
Search Description : 'RECTIFIER'
Total: 1/1,678 Pages
- Transistor(28,210)
Search Description : 'TRANSISTOR'
Total: 1/2,166 Pages
- Led(23,211)
Search Description : 'LED'
Total: 1/1,817 Pages
- Triac(704)
Search results
Results from the WOW.Com Content Network
It is also worth noting that the temperature coefficient of a 4.7 V Zener diode is close to that of the emitter-base junction of a silicon transistor at around −2 mV/°C, so in a simple regulating circuit where the 4.7 V diode sets the voltage at the base of an NPN transistor (i.e. their coefficients are acting in parallel), the emitter will ...
Reference voltage vs free-air temperature at test conditions. Design-center (middle plot) and worst-case deviation of ±2% (upper and lower plots) [12] The nominal reference voltage, V REF =2.495 V, stated in a datasheet, is tested in zener mode at an ambient temperature of +25 °C (77 °F), and I CA =10 mA. [13]
Here, the load current I R2 is supplied by the transistor whose base is now connected to the Zener diode. Thus the transistor's base current (I B) forms the load current for the Zener diode and is much smaller than the current through R 2. This regulator is classified as "series" because the regulating element, viz., the transistor, appears in ...
In graphical analysis of nonlinear electronic circuits, a load line is a line drawn on the current–voltage characteristic graph for a nonlinear device like a diode or transistor. It represents the constraint put on the voltage and current in the nonlinear device by the external circuit.
A low line regulation is always preferred. In practice, a well regulated power supply should have a line regulation of at most 0.1%. [1] In the regulator device datasheets the line regulation is expressed as percent change in output with respect to change in input per volt of the output. Mathematically it is expressed as:
The Shockley diode equation relates the diode current of a p-n junction diode to the diode voltage .This relationship is the diode I-V characteristic: = (), where is the saturation current or scale current of the diode (the magnitude of the current that flows for negative in excess of a few , typically 10 −12 A).
In the Zener diode, the concept of PIV is not applicable. A Zener diode contains a heavily doped p–n junction allowing electrons to tunnel from the valence band of the p-type material to the conduction band of the n-type material, such that the reverse voltage is "clamped" to a known value (called the Zener voltage), and avalanche does not ...
The transfer characteristic has exactly the same shape of the previous basic configuration, and the threshold values are the same as well. On the other hand, in the previous case, the output voltage was depending on the power supply, while now it is defined by the Zener diodes (which could also be replaced with a single double-anode Zener diode).
Ad
related to: datasheet of zener diode in parallel line analysis system