Search results
Results from the WOW.Com Content Network
The Sterling 10.5 axle is an automotive axle manufactured by Ford Motor Company at the Sterling Axle Plant in Sterling Heights, MI. It was first used in model year 1985 Ford trucks. The axle was developed to replace the Dana 60 and Dana 70. The Sterling 10.5 axle is currently only made as a full floating axle.
Download as PDF; Printable version; ... Pages in category "Automobile axles" The following 16 pages are in this category, out of 16 total. ... Sterling 10.5 axle
The four-wheel-drive models had an NV273 transfer case and Dana 50 front axle. Rear axle ratios of 3.73:1 and 4.30:1 were offered. Rear axle ratios of 3.73:1 and 4.30:1 were offered. During the development of the chassis, Ford learned that its initial design caused smaller vehicles (such as a Ford Taurus ) to become severely overridden in a ...
The 10.5" 14-bolt differential and axle is quite popular with Jeep Wrangler owners who want to upgrade their standard Dana 30, Dana 35, or Dana 44 axle. While the 10.5" 14-bolt axle is heavier than the standard Dana axles offered on the Wrangler, it is much stronger.
The same year, Ford introduced the H-Series heavy truck. Derived from the C-Series, the H-Series mounted the cab higher on an all-new chassis with a forward-mounted axle (taking on the "Two-Story Falcon" nickname); while a Super Duty V8 was standard, the optional Cummins NH inline-6 was the first factory-installed diesel offered in a Ford truck ...
The Dana 70 axle only came with 5.13:1, 4.88,5.31 [citation needed] gear ratios and had a GAWR of [citation needed] these axles were rated at 7-9klbs as seen on 5500 door stickers. They differ greatly from previous Dana 70 front axles, some of the major differences being the use of 1550 Universal Joints and being a high pinion, reverse cut axle.
Dana differential case #706400 [3] (3.07-3.73) shows in Dana's parts catalog to be Dana 61-specific [citation needed]. The 706040x carrier can be purchased relatively inexpensively and used to install lower gears in a Dana 61 axle, such as when replacing a broken or damaged Dana 60 with a Dana 61 while retaining the factory gear ratio.
It can be identified by its straight axle tubes, 10 bolt asymmetrical cover, and a "80" cast into the housing. Dana 80's are made as full floating, rear axles only and are a step up in overall strength compared to the Dana 70. 1988 Ford was the first company to use the Dana 80.