enow.com Web Search

  1. Ads

    related to: repairing a garage door cable installation instructions

Search results

  1. Results from the WOW.Com Content Network
  2. Garage door - Wikipedia

    en.wikipedia.org/wiki/Garage_door

    Sectional garage door Up-and-over garage door Garage Door Hardware. A garage door is a large door to allow egress for a garage that opens either manually or by an electric motor (a garage door opener). Garage doors are frequently large enough to accommodate automobiles and other vehicles. The operating mechanism is usually spring-loaded or ...

  3. Garage door opener - Wikipedia

    en.wikipedia.org/wiki/Garage_door_opener

    The electric overhead garage door opener was invented by C.G. Johnson in 1926 in Hartford City, Indiana. [1] Electric Garage Door openers did not become popular until Era Meter Company of Chicago offered one after World War II where the overhead garage door could be opened via a key pad located on a post at the end of the driveway or a switch inside the garage.

  4. Cable harness - Wikipedia

    en.wikipedia.org/wiki/Cable_harness

    A cable laced wiring harness installed in a component of a Tesla coil Harness of car audio cables.. A cable harness, also known as a wire harness, wiring harness, cable assembly, wiring assembly or wiring loom, is an assembly of electrical cables or wires which transmit signals or electrical power. [1]

  5. Direct-buried cable - Wikipedia

    en.wikipedia.org/wiki/Direct-buried_cable

    Cross-section of direct buried cable. Direct-buried cable (DBC) is a kind of communications or transmissions electrical cable which is especially designed to be buried under the ground without any other cover, sheath, or duct to protect it. [1] Most direct-buried cable is built to specific tolerances to heat, moisture, conductivity, and soil ...

  6. Guy-wire - Wikipedia

    en.wikipedia.org/wiki/Guy-wire

    This type consists of a rod with wide screw blades on the end and an eyelet on the other for the guy wire. It is screwed deep into the ground, at the same angle as the guy, by a truck-mounted drill machine. These are commonly used as guy anchors for utility poles since they are quick to install with a truck mounted hydraulic powered auger drive.

  7. Light switch - Wikipedia

    en.wikipedia.org/wiki/Light_switch

    This "double gang" (two unit) installation uses non-metallic-sheathed cable and twist-on wire connectors. In electrical wiring , a light switch is a switch most commonly used to operate electric lights , permanently connected equipment, or electrical outlets .

  1. Ads

    related to: repairing a garage door cable installation instructions