Search results
Results from the WOW.Com Content Network
The most notable difference from modern 20/24-pin ATX power connectors is that the AT power supply connector did not have a signal to turn on the power supply, and also did not supply separate, "always-on" +5V standby power. The power supply was instead turned on and off via a mechanical switch that disconnected mains power.
An automotive wiring diagram, showing useful information such as crimp connection locations and wire colors. These details may not be so easily found on a more schematic drawing. A wiring diagram is a simplified conventional pictorial representation of an electrical circuit. It shows the components of the circuit as simplified shapes, and the ...
Calling that shield a shell (or D-shell) can be ambiguous, as the term shell is also short for the cable shell, or backshell. D-sub connectors have gender: parts with pin contacts are called male connectors or plugs, while those with socket contacts are called female connectors or sockets. The socket's shield fits tightly inside the plug's shield.
PS-ON Signal is a pin on a 20-pin or 24-pin ATX-specified power connector used to turn a personal computer power supply unit on/off. The PS_ON pin is normally pulled high in an open-circuit, but will turn on the power supply when it is pulled low, by shorting it to the common signal (COM). Conversely the power supply is turned off when the PS ...
30 pin receptacle including the following electrical interfaces: 2-lane DisplayPort v1.1a, USB 3.0, USB On-The-Go, Analog stereo line-out, HDMI CEC for remote control, high output power line from both host and portable device Male Mini-VGA plug on top of an Apple laptop, female port is second from right. Mini-VGA (used for laptops)
A power supply with a 24-pin connector can be used on a motherboard with a 20-pin connector. In cases where the motherboard has a 24-pin connector, some power supplies come with two connectors (one with 20-pin and other with 4-pin, i.e. 20+4-pin form) which can be used together to form the 24-pin connector.
The power connector was typically the same 4-pin female Molex connector used in many other internal computer devices. The communication connectors on the drives were usually a 50 (for 8-bit SCSI) or 68 pin male (for 16-bit SCSI) " IDC header " which has two rows of pins, 0.1 inches apart.
Cutaway diagram of a shielded multicore cable with four cores each with three individual conductors. A multicore cable is a type of electrical cable that combines multiple signals or power feeds into a single jacketed cable. [1] The term is normally only used in relation to a cable that has more cores than commonly encountered. [2]