Search results
Results from the WOW.Com Content Network
The Intel 8085 ("eighty-eighty-five") is an 8-bit microprocessor produced by Intel and introduced in March 1976. [2] It is the last 8-bit microprocessor developed by Intel. It is software-binary compatible with the more-famous Intel 8080 with only two minor instructions added to support its added interrupt and serial input/output features.
The Intel BCD opcodes are a set of six x86 instructions that operate with binary-coded decimal numbers. The radix used for the representation of numbers in the x86 processors is 2. This is called a binary numeral system. However, the x86 processors do have limited support for the decimal numeral system.
The instruction set architecture (ISA) that the computer final version (SAP-3) is designed to implement is patterned after and upward compatible with the ISA of the Intel 8080/8085 microprocessor family. Therefore, the instructions implemented in the three SAP computer variations are, in each case, a subset of the 8080/8085 instructions. [2]
Compare instruction (equivalent to a subtract instruction without storing the result); Logical instructions - XOR, AND, OR; the TEST instruction (equivalent to the AND instruction without storing the result). Instructions which write to the entire flags register: POPF, IRET, interrupts, or any other instruction which causes a hardware task switch.
Below is the full 8086/8088 instruction set of Intel (81 instructions total). [2] These instructions are also available in 32-bit mode, in which they operate on 32-bit registers (eax, ebx, etc.) and values instead of their 16-bit (ax, bx, etc.) counterparts.
Most instructions have one or more opcode fields that specify the basic instruction type (such as arithmetic, logical, jump, etc.), the operation (such as add or compare), and other fields that may give the type of the operand(s), the addressing mode(s), the addressing offset(s) or index, or the operand value itself (such constant operands ...
The x86 architecture is a variable instruction length, primarily "CISC" design with emphasis on backward compatibility. The instruction set is not typical CISC, however, but basically an extended version of the simple eight-bit 8008 and 8080 architectures.
The logical formula of the zero flag for a twos-complement binary operand is NOT(OR(all bits of the operand in question)). In most processors, the zero flag is mainly used in conditional branch instructions, which alter control flow on previous instruction results, but there are often other uses as well.