Search results
Results from the WOW.Com Content Network
The following diode logic gates work in both active-high or active-low logic, however the logical function they implement is different depending on what voltage level is considered active. Switching between active-high and active-low is commonly used to achieve a more efficient logic design.
Diode–transistor logic (DTL) is a class of digital circuits that is the direct ancestor of transistor–transistor logic. It is called so because the logic gating functions AND and OR are performed by diode logic , while logical inversion (NOT) and amplification (providing signal restoration) is performed by a transistor (in contrast with ...
A family of diode logic and diode–transistor logic integrated circuits was developed by Texas Instruments for the D-37C Minuteman II Guidance Computer in 1962, but these devices were not available to the public. A variant of DTL called "high-threshold logic" incorporated Zener diodes to create a large offset between logic 1 and logic 0 ...
The digital data representing "K" (0x4b) as 7-bit ASCII is framed as "7E1" with 1 start bit, 7 data bits, even parity, 1 stop bit. The use of either the higher or the lower voltage level to represent either logic state is arbitrary. The two options are active high (positive logic) and active low (negative logic).
Diode–transistor logic improved the fan-out up to about 7, and reduced the power. Some DTL designs used two power supplies with alternating layers of NPN and PNP transistors to increase the fan-out. Transistor–transistor logic (TTL) was a great improvement over these. In early devices, fan-out improved to 10, and later variations reliably ...
[1] [2] In the same family are ULN2002A, ULN2004A, as well as ULQ2003A and ULQ2004A, designed for different logic input levels. The ULN2003A is also similar to the ULN2001A (4 inputs) and the ULN2801A, ULN2802A, ULN2803A, ULN2804A and ULN2805A, only differing in logic input levels ( TTL , CMOS , PMOS ) and number of in/outputs (4/7/8).
A wired logic connection is a logic gate that implements boolean algebra (logic) using only passive components such as diodes and resistors. A wired logic connection can create an AND or an OR gate. Limitations include the inability to create a NOT gate, the lack of amplification to provide level restoration, and its constant ohmic heating for ...
There is also IEC 61131-3 – for ladder-logic symbols. JIC JIC (Joint Industrial Council) symbols as approved and adopted by the NMTBA (National Machine Tool Builders Association). They have been extracted from the Appendix of the NMTBA Specification EGPl-1967. ANSI Y32.2-1975 (also known as IEEE Std 315-1975 [1] or CSA Z99-1975).