Search results
Results from the WOW.Com Content Network
The bubble/foam-making process is irreversible and endothermic, i.e. it needs heat (e.g. from a melt process or the chemical exotherm due to cross-linking), to volatilize a liquid blowing agent. However, on cooling process, the blowing agent will condense, which is a reversible process. [2] [3]
In particular, they looked at maximum heat release and time to maximum heat release, two key indicators of fire danger. These studies found that the type of fabric covering had a large influence on ease of ignition, that cotton fillings were much less flammable than polyurethane foam fillings, and that an interliner material substantially ...
The heat transfer characteristic of epoxy tooling is fair; the heat transfer characteristic of metal-filled and metal-coated epoxy is good. Copper tubing can be incorporated into the body of the tool, allowing hot water to circulate and heat the mold surface. Aluminum is used for tooling that has an EOL in the hundreds of thousands of parts.
It can handle neutral and denser-than-air gases or aerosols from ground-level or elevated sources. The model accommodates building and terrain effects, evaporation of volatile liquid spill pools, and combustion or explosion of flammable gas-air mixtures (including the impact of heat and pressure waves caused by a fire or explosion).
The original mass of flammable material and the mass of the oxygen consumed (typically from the surrounding air) equals the mass of the flame products (ash, water, carbon dioxide, and other gases). Lavoisier used the experimental fact that some metals gained mass when they burned to support his ideas (because those chemical reactions capture ...
Polyurethane dispersion, or PUD, is understood to be a polyurethane polymer resin dispersed in water, rather than a solvent, although some cosolvent may be used.Its manufacture involves the synthesis of polyurethanes having carboxylic acid functionality or nonionic hydrophiles like PEG (polyethylene glycol) incorporated into, or pendant from, the polymer backbone. [1]
The time it takes for a material to reach its autoignition temperature when exposed to a heat flux ″ is given by the following equation: [4] = [″], where k = thermal conductivity, ρ = density, and c = specific heat capacity of the material of interest, is the initial temperature of the material (or the temperature of the bulk material).
Water Quenched 30.5 31.0 31.8 Tempered at 150°C and air cooled 32.2 32.2 32.8 Tempered at 200°C and air cooled 33.1 33.9 33.5 Tempered at 250°C and air cooled 36.8 36.4 37.2 Tempered at 300°C and air cooled 37.7 38.5 38.1 Tempered at 350°C and air cooled 38.1 38.5 38.9