Search results
Results from the WOW.Com Content Network
The Vickers hardness test was developed in 1921 by Robert L. Smith and George E. Sandland at Vickers Ltd as an alternative to the Brinell method to measure the hardness of materials. [1] The Vickers test is often easier to use than other hardness tests since the required calculations are independent of the size of the indenter, and the indenter ...
This is the pumping mechanism for the historical vane pump or motor. The term 'pressure balanced' comes from the fact that pressure in any chamber is matched by the same pressure in the diametrically opposite chamber and the hydraulic radial side thrust calculated by a 'side view area' and the two forces are opposite and cancel; hence the name ...
Gear pumps [1] [2] trochoid pumps [3] and vane pumps [a] are all commonly used. Plunger pumps have been used in the past, but these are now only used rarely, for small engines. To avoid the need for priming, the pump is always mounted low-down, either submerged or around the level of the oil in the sump. A short pick-up pipe with a simple wire ...
An eccentric rotary vane pump Another eccentric rotary-vane pump design. Note that modern pumps have an area contact between rotor and stator (and not a line contact). 1. pump housing 2. rotor 3. vanes 4. spring. A rotary vane pump is a type of positive-displacement pump that consists of vanes mounted to a rotor that rotates inside a cavity. In ...
Cutaway side-view diagram of an axial piston pump 3-D rendering of an axial piston pump with the parts labeled Animation of an axial piston pump in operation. An axial piston pump has a number of pistons (usually an odd number) arranged in a circular array within a housing which is commonly referred to as a cylinder block, rotor or barrel.
Different types of pumps are suitable for different applications, for example: a pump's maximum lift height also determines the applications it can be used for. Low-lift pumps are only suitable for the pumping of surface water (e.g., irrigation, drainage of lands, ...), while high-lift pumps allow deep water pumping (e.g., potable water pumping ...
The most common measuring stick for relief pitchers is the number of saves. Hall members Hoffman (601) and Mariano Rivera (652) are far and away the all-time leaders, with Wagner considerably ...
Compressors are similar to pumps: both increase the pressure on a fluid (such as a gas) and both can transport the fluid through a pipe.The main distinction is that the focus of a compressor is to change the density or volume of the fluid, which is mostly only achievable on gases.