Search results
Results from the WOW.Com Content Network
A check engine light or malfunction indicator lamp (MIL), is a tell-tale that a computerized engine-management system uses to indicate a malfunction or problem with the vehicle ranging from minor (such as a loose gas cap) to serious (worn spark plugs, engine problems or a faulty oil valve, etc.).
The oil pressure idiot light lights when engine oil pressure drops below a predetermined level. The light normally appears when the vehicle ignition is turned on, but the engine is not running, as it detects no oil pressure due to the oil pump not operating (the oil pump is powered off the crankshaft, so only operates when the engine is running ...
The switch is automatically operated by a cam driven by the engine. The timing of operation of the switch is set so that a spark is produced at the right time to ignite the compressed air/fuel mixture in the cylinder of the engine. A mechanism may be provided to slightly adjust timing to allow for varying load on the engine.
Even more advanced devices allow users to reset engine DTC codes, effectively turning off engine lights in the dashboard; however, resetting the codes does not address the underlying issues and can in worst-case scenarios even lead to engine breakage where the source issue is serious and left unattended for long periods.
Crankshaft position sensor (CKP) Curb feeler; Defect detector; Engine coolant temperature sensor; Hall effect sensor; Wheel speed sensor; Airbag sensors; Automatic transmission speed sensor; Brake fluid pressure sensor; Camshaft position sensor (CMP) Cylinder Head Temperature gauge; Engine crankcase pressure sensor; Exhaust gas temperature ...
This kind of electronic control is less common in piston-engined light fixed-wing aircraft and helicopters than in automobiles. This is due to the common configuration of a carbureted engine with a magneto ignition system that does not require electrical power generated by an alternator to run, which is considered a safety advantage. [12]
The electric immobiliser/alarm system was invented by St. George Evans and Edward Birkenbeuel and patented in 1919. [2] They developed a 3x3 grid of double-contact switches on a panel mounted inside the car so when the ignition switch was activated, current from the battery (or magneto) went to the spark plugs allowing the engine to start, or immobilizing the vehicle and sounding the horn. [3]
The TPS sensor along with the vehicle speed sensor are the two main inputs for most TCUs. Older transmissions use this to determine engine load, with the introduction of drive-by-wire technology, this is often a shared input between the ECU and TCU. The input is used to determine the optimum time and characteristics for a gear change according ...