enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Dead man's switch - Wikipedia

   en.wikipedia.org/wiki/Dead_man's_switch

   Interest in dead man's controls increased with the introduction of electric trams (streetcars in North America) and especially electrified rapid transit trains. The first widespread use came with the introduction of the mass-produced Birney One-Man Safety (tram) Car, though dead-man equipment was fairly rare on US streetcars until the successful PCC streetcar, which had a left-foot-operated ...

3. Equipment of Strategic Air Command - Wikipedia

   en.wikipedia.org/wiki/Equipment_of_Strategic_Air...

   This system (SWESS), also known informally as the dead man's switch, was a nuclear bomb release system that the United States Air Force Strategic Air Command built into bombers such as the B-52 Stratofortress.

4. DeWalt - Wikipedia

   en.wikipedia.org/wiki/DeWalt

   On September 1, 2016, DeWalt debuted its FlexVolt hybrid voltage battery pack that can switch between series battery wiring providing 60 V (54 V nominal) and 2 Ah, or parallel wiring for 20 V (18 V nominal) and 6 Ah, depending on whether it is installed in a 60 V or 20 V tool, determined by communication between the tool and battery. [10]

5. Angle grinder - Wikipedia

   en.wikipedia.org/wiki/Angle_grinder

   An angle grinder, also known as a side grinder or disc grinder, is a handheld power tool used for grinding (abrasive cutting) and polishing. Although developed originally as tools for rigid abrasive discs, the availability of an interchangeable power source has encouraged their use with a wide variety of cutters and attachments.

6. Tool and cutter grinder - Wikipedia

   en.wikipedia.org/wiki/Tool_and_cutter_grinder

   The D-bit (after Friedrich Deckel, [1] the brand of the original manufacturer) grinder is a tool bit grinder designed to produce single-lip cutters for pantograph milling machines. Pantographs are a variety of milling machine used to create cavities for the dies used in the molding process ; they are largely obsolete and replaced by CNC ...

7. Grinding (abrasive cutting) - Wikipedia

   en.wikipedia.org/wiki/Grinding_(abrasive_cutting)

   The tolerances that are normally achieved with surface grinding are ±2 × 10 −4 inches (5.1 μm) for grinding a flat material and ±3 × 10 −4 inches (7.6 μm) for a parallel surface. [4] The surface grinder is composed of an abrasive wheel, a workholding device known as a chuck, either electromagnetic or vacuum, and a reciprocating table.