Search results
Results from the WOW.Com Content Network
This is the case on many large aircraft such as the 747, C-17, KC-10, etc. If you are on an aircraft and you hear the engines increasing in power after landing, it is usually because the thrust reversers are deployed. The engines are not actually spinning in reverse, as the term may lead you to believe.
Advanced Supersonic Transport (AST) model in wind tunnel. The aircraft design process is a loosely defined method used to balance many competing and demanding requirements to produce an aircraft that is strong, lightweight, economical and can carry an adequate payload while being sufficiently reliable to safely fly for the design life of the aircraft.
Then, the air usually will pass through a water separator coalescer or the sock. The sock retains the dirt and oil from the engine bleed air to keep the cabin air cleaner. This water removal process prevents ice from forming and clogging the system, and keeps the cockpit and cabin from fogging on ground operation and low altitudes.
An interesting feature of all three German jet engine designs that saw production of any kind before May 1945 (the German BMW 003, Junkers Jumo 004 and Heinkel HeS 011 axial-flow turbojet engine designs) was the starter system, which consisted of a Riedel 10 hp (7.5 kW) flat twin two-stroke air-cooled engine hidden in the intake, and ...
Honeywell maintenance program is $447 for two engines per hour. [5] Borescope inspections extends time between overhaul and some engines have remained installed for up to 10,000 hr. [ 3 ] It has line replaceable components installed with hand tools and is designed for condition-based maintenance .
The engine maintenance interval (time-on-wing) is increased from 14,000 hours to 20,000 hours and would use three percent less fuel than the PW127M. [6] The engine series will premiere as the standard powerplant on all new ATR 42 and ATR 72 aircraft, with a launch order from Air Corsica using the PW127XT-M engine model. The PW127XT-N variant ...
The production engines were fitted on the EMD/production F-22, and were first flown on the aircraft's maiden flight on 7 September 1997. [ 8 ] [ 9 ] A total of 507 engines were produced. [ 10 ] The F119 Heavy Maintenance Center (HMC) for depot overhaul is located at Tinker Air Force Base, Oklahoma, with the first overall completed in 2013.
The engine was first tested on the Pratt & Whitney Boeing 747SP on July 11, 2008 through mid-August 2008, totaling 12 flights and 43.5 flight hours. [14] It then flew starting October 14, 2008 on an Airbus A340-600 in Toulouse on the number two pylon. [15] Testing of the CSeries bound PW1524G model began in October 2010. [16]