Search results
Results from the WOW.Com Content Network
For use in industrial processes, adhesive is supplied in larger sticks and glue guns with higher melting rates. Aside from hot-melt sticks, HMA can be delivered in other formats such as granular or power hot-melt blocks for bulk melt processors. Larger applications of HMA traditionally use pneumatic systems to supply adhesive. [43]
Heat seal connectors are used to join LCDs to PCBs in many consumer electronics, as well as in medical and telecommunication devices.. Heat sealing of products with thermal adhesives is used to hold clear display screens onto consumer electronic products and for other sealed thermo-plastic assemblies or devices where heat staking or ultrasonic welding are not an option due to part design ...
A glue gun (shown at right) is one method of applying hot adhesives. The glue gun melts the solid adhesive, then allows the liquid to pass through its barrel onto the material, where it solidifies. Thermoplastic glue may have been invented around 1940 by Procter & Gamble as a solution to the problem that water-based adhesives, commonly used in ...
Hot melt coating is the application of a layer to a substrate by pre-melting the desired material and then allowing or forcing the material to cool, solidifying the layer. The process is widely used in industry, including pressure-sensitive adhesives , [ 1 ] labels, pharmaceuticals, [ 2 ] etc.
A hot air gun or hot air station is used to heat devices and melt solder, and specialised tools are used to pick up and position often tiny components. A rework station is a place to do this work—the tools and supplies for this work, typically on a workbench .
It is most commonly used for regular slotted containers (RSC) and can involve adhesive (cold water-borne or hot melt adhesive), box sealing tape, or gummed (water activated) tape. By contrast, a case erector is equipment for setting-up flat (knocked-down) corrugated boxes and applying a closure to the bottom flaps.
The detonation gun consists of a long water-cooled barrel with inlet valves for gases and powder. Oxygen and fuel (acetylene most common) are fed into the barrel along with a charge of powder. A spark is used to ignite the gas mixture, and the resulting detonation heats and accelerates the powder to supersonic velocity through the barrel.
The blowtorch is commonly used where a diffuse (wide spread) high temperature naked flame heat is required but not so hot as to cause combustion or welding.Temperature applications are soldering, brazing, softening paint for removal, melting roof tar, or pre-heating large castings before welding such as for repairing.