Search results
Results from the WOW.Com Content Network
BIM & 3D modeling software applied for civil & structural engineering STAAD: BIM & 3D structural analysis & design software for structural engineers Tekla Structures: BIM & 3D modeling software for civil & structural engineers PLPAK: Reinforced concrete slab analysis and design & BIM structural static and dynamic analysis
Tilt-up, tilt-slab or tilt-wall is a type of building and a construction technique using concrete. Though it is a cost-effective technique with a shorter completion time, [ 1 ] poor performance in earthquakes has mandated significant seismic retrofit requirements in older buildings.
Lift slab construction (also called the Youtz-Slick Method) is a method of constructing concrete buildings by casting the floor or roof slab on top of the previous slab and then raising (jacking) the slab up with hydraulic jacks. This method of construction allows for a large portion of the work to be completed at ground level, negating the ...
Suspended slab under construction, with the formwork still in place Suspended slab formwork and rebar in place, ready for concrete pour. A concrete slab is a common structural element of modern buildings, consisting of a flat, horizontal surface made of cast concrete. Steel-reinforced slabs, typically between 100 and 500 mm thick, are most ...
Rebar detailing is the discipline of preparing 'shop/placing' or 'fabrication' drawings or shop drawings of steel reinforcement for construction. Engineers prepare 'design drawings' that develop required strengths by applying rebar size, spacing, location, and lap of steel .
Installation information will need to be reviewed with electrical and plumbing trades to coordinate third-party service connections. A shop drawing is a drawing or set of drawings produced by the contractor , supplier , manufacturer, subcontractor , consultants, or fabricator .
Pre-tensioned concrete is a variant of prestressed concrete where the tendons are tensioned prior to the concrete being cast. [1]: 25 The concrete bonds to the tendons as it cures, following which the end-anchoring of the tendons is released, and the tendon tension forces are transferred to the concrete as compression by static friction.
Initiation and propagation periods of steel rebar corrosion in a reinforced concrete structure (Tutti diagram). [2] [3] Initially, the chemical reactions that normally occur in the cement paste, generate an alkaline environment, bringing the solution in the cement paste pores to pH values around 13. In these conditions, passivation of steel ...