enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Pulse-width modulation - Wikipedia

   en.wikipedia.org/wiki/Pulse-width_modulation

   Adjusting the brightness of light emitted by a light source is then merely a matter of setting at what voltage (or phase) in the AC half-cycle the dimmer begins to provide electric current to the light source (e.g. by using an electronic switch such as a triac). In this case the PWM duty cycle is the ratio of the conduction time to the duration ...

3. 0-10 V lighting control - Wikipedia

   en.wikipedia.org/wiki/0-10_V_lighting_control

   The switch is controlled by a PWM (Pulse Width Modulation) signal, which alternately turns the switch on and off at a rapid rate. The relative proportion of off time vs. on time determines brightness. For example, if the switch is off 10% of the time, the resulting control signal would be the equivalent of 1 V produced with a variable resistor.

4. Dimmer - Wikipedia

   en.wikipedia.org/wiki/Dimmer

   When the dimmer is at 50% power, the switches are switching their highest voltage (>325 V in Europe) and the sudden surge of power causes the coils on the inductor to move, creating a buzzing sound associated with some types of dimmer; this same effect can be heard in the filaments of the incandescent lamps as "singing". The suppression ...

5. Chopper (electronics) - Wikipedia

   en.wikipedia.org/wiki/Chopper_(electronics)

   The longer the switch is on compared to the off periods, the higher the total power supplied to the load. The PWM switching frequency has to be much higher than what would affect the load (the device that uses the power), which is to say that the resultant waveform perceived by the load must be as smooth as possible.

6. Phase-fired controller - Wikipedia

   en.wikipedia.org/wiki/Phase-fired_controller

   The most common application is in dimmer switches for domestic lighting control. For industrial applications previously, extremely expensive and heavy multi-tapped transformers were used as the supplies for such elements, with the corresponding winding tap being connected to the element to produce the desired temperature. This limited the ...

7. Switching control techniques - Wikipedia

   en.wikipedia.org/wiki/Switching_Control_Techniques

   PWM is considered the most common deterministic technique. Considering the example of a DC-DC converter, a controlled switch is designed to “cut-off” the DC waveform into a pulse-shaped waveform. Therefore, the voltage of this signal alternates at the switching frequency between a maximum value and zero.