enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   Push-to-pull fittings are easily removed compression fitting that allows pipes to be connected with minimal tools. These fittings are similar to regular compression fittings but use an O-ring for sealing and a grip ring to hold the pipe. The main advantage is that it can easily be removed and re-used, it is easy to assemble, and the joints are ...

3. Compression fitting - Wikipedia

   en.wikipedia.org/wiki/Compression_fitting

   A compression fitting 15 mm isolating valve. A compression fitting is a fitting used in plumbing and electrical conduit systems to join two tubes or thin-walled pipes together. . In instances where two pipes made of dissimilar materials are to be joined (most commonly PVC and copper), the fittings will be made of one or more compatible materials appropriate for the connect

4. Push-to-pull compression fittings - Wikipedia

   en.wikipedia.org/wiki/Push-to-pull_compression...

   A push-in compression coupling and tee.. Push-to-pull, push-to-connect, push-in, push-fit, or instant fittings are a type of easily removed compression fitting or quick connect fitting that allows an air (or water) line to be attached, nominally without the use of tools (a tool is still usually required for cutting tubing to length and removal).

5. AN thread - Wikipedia

   en.wikipedia.org/wiki/AN_thread

   [1] AN sizes range from -2 (dash two) to -32 in irregular steps, with each step equating to the OD (outside diameter) of the tubing in 1 ⁄ 16-inch increments. Therefore, a -8 AN size would be equal to 1 ⁄ 2-inch OD tube. However, this system does not specify the ID (inside diameter) of the tubing because the tube wall can vary in thickness.

6. Hose clamp - Wikipedia

   en.wikipedia.org/wiki/Hose_clamp

   Screw clamps are normally used for hoses 1/2 inch diameter and up, with other clamps used for smaller hoses. The first patent for a worm-drive hose clamp was granted to Swedish inventor Knut Edwin Bergström [ se ] in 1896 [ 1 ] Bergström founded “Allmänna Brandredskapsaffären E. Bergström & Co.” in 1896 (ABA) to manufacture these worm ...

7. National pipe thread - Wikipedia

   en.wikipedia.org/wiki/National_pipe_thread

   The half-angle (between the taper surface and the axis of the pipe) is arctan(1 ⁄ 32) ≈ 1.7899° ≈ 1° 47′. The standard for Nominal Pipe Size (often abbreviated NPS, which should not be confused with the abbreviation NPS for the straight thread form standard) is loosely related to the inside diameter of Schedule 40 series of sizes.