Search results
Results from the WOW.Com Content Network
Peripheral Component Interconnect (PCI) [3] is a local computer bus for attaching hardware devices in a computer and is part of the PCI Local Bus standard. The PCI bus supports the functions found on a processor bus but in a standardized format that is independent of any given processor's native bus.
A four-port serial (RS-232) PCI Express ×1 expansion card with an octopus cable that breaks the card's DC-37 connector into four standard DE-9 connectors A converter from USB to an RS-232 compatible serial port—more than a physical transition, it requires a driver in the host system software and a built-in processor to emulate the functions ...
COM port (DE-9 connector). COM (communication port) [1] [2] is the original, yet still common, name of the serial port interface on PC-compatible computers. It can refer not only to physical ports, but also to emulated ports, such as ports created by Bluetooth or USB adapters.
Conceptually, the PCI Express bus is a high-speed serial replacement of the older PCI/PCI-X bus. [8] One of the key differences between the PCI Express bus and the older PCI is the bus topology; PCI uses a shared parallel bus architecture, in which the PCI host and all devices share a common set of address, data, and control lines.
Serial Peripheral Interface (SPI) is a de facto standard (with many variants) for synchronous serial communication, used primarily in embedded systems for short-distance wired communication between integrated circuits.
BNU is a high-performance communications device driver designed to provide enhanced support for serial port communications. The BNU serial port driver was specifically targeted for use with early (late 1980s - 1990s) DOS-based BBS software. The reason for BNU and other similar enhanced serial port drivers was to provide better support for ...
A DB-25 connector as described in the RS-232 standard Data circuit-terminating equipment (DCE) and data terminal equipment (DTE) network. In telecommunications, RS-232 or Recommended Standard 232 [1] is a standard originally introduced in 1960 [2] for serial communication transmission of data.
At a lower level, a device driver implementing these functions would communicate to the particular serial port controller installed on a user's computer. The commands needed to control a 16550 UART are much different from the commands needed to control an FTDI serial port converter, but each hardware-specific device driver abstracts these ...