Search results
Results from the WOW.Com Content Network
Self-Priming centrifugal pumps were invented in 1935. One of the first companies to market a self-priming centrifugal pump was American Marsh in 1938. [citation needed] Centrifugal pumps that are not designed with an internal or external self-priming stage can only start to pump the fluid after the pump has initially been primed with the fluid.
Endorse this file for transfer by adding |human=<your username> to this Template.; If this file is freely licensed, but otherwise unsuitable for Commons (e.g. out of Commons' scope, still copyrighted in the US), then replace this Template with {{Do not move to Commons|reason=<Why it can't be moved>}}
An axial-flow pump for industrial use. An axial-flow pump, or AFP, is a common type of pump that essentially consists of a propeller (an axial impeller) in a pipe.The propeller can be driven directly by a sealed motor in the pipe or by electric motor or petrol/diesel engines mounted to the pipe from the outside or by a right-angle drive shaft that pierces the pipe.
The simplest inlet to a centrifugal compressor is typically a simple pipe. Depending upon its use/application inlets can be very complex. They may include other components such as an inlet throttle valve, a shrouded port, an annular duct (see Figure 1.1), a bifurcated duct, stationary guide vanes/airfoils used to straight or swirl flow (see Figure 1.1), movable guide vanes (used to vary pre ...
Pump and volute casing. A volute is a curved funnel that increases in area as it approaches the discharge port. [1] The volute of a centrifugal pump is the casing that receives the fluid being pumped by the impeller, maintaining the velocity of the fluid through to the diffuser. As liquid exits the impeller it has high kinetic energy and the ...
A centrifugal clutch shown in a patent application, 1898. Centrifugal clutches were used in railway locomotives before 1858, [1] and referred to (in relation to electric motors) in a patent of 1899. [2] A patent was issued in the United States for an automotive centrifugal clutch (on an electric vehicle) in 1898. [3]
Generally, axial pumps tend to give much lower pressures than centrifugal pumps, and a few bars is not uncommon. Their advantage is a much higher volumetric flowrate. For this reason they are common for pumping liquid hydrogen in rocket engines, because of its much lower density than other propellants which usually use centrifugal pump designs.
Centrifugal governors are used in many modern repeating watches to limit the speed of the striking train, so the repeater does not run too quickly. Another kind of centrifugal governor consists of a pair of masses on a spindle inside a cylinder, the masses or the cylinder being coated with pads, somewhat like a centrifugal clutch or a drum brake.