Search results
Results from the WOW.Com Content Network
The Ford EEC (Electronic Engine Control) system, which utilized the Toshiba TLCS-12 microprocessor, went into mass production in 1975. [ 7 ] The first Bosch engine management system was the Motronic 1.0 , which was introduced in the 1979 BMW 7 Series (E23) [ 8 ] This system was based on the existing Bosch Jetronic fuel injection system, to ...
On October 16, 2008 the NTSB recommended that the FAA issue urgent new inspection procedures on the PW2037 model of the engine, following an uncontained turbine failure event in August 2008. The NTSB recommended that the FAA order PW2037 engines inspected beyond a threshold of flight hours or flight cycles less than that of the event engine ...
The YF119-PW-614 on the X-32 had a pitch-axis thrust vectoring nozzle and valves can redirect the engine exhaust and bleed air to provide direct lift, similar to the Pegasus engine on the Harrier. In contrast, YF119-PW-611 on the X-35 had a round axisymmetric nozzle that can swivel downwards while the low-pressure spool drives a lift fan that's ...
The engines involved in the July and September incidents had 154 and 230 cycles, respectively, while the October failure occurred to an engine with 1,654 cycles since new but within 300 cycles after an electronic engine-control update. Pratt & Whitney recommends inspections on engines with up to 300 cycles after the update.
An engine test stand is a facility used to develop, characterize and test engines. The facility, often offered as a product to automotive OEMs , allows engine operation in different operating regimes and offers measurement of several physical variables associated with the engine operation.
FADEC also monitors a variety of data coming from the engine subsystems and related aircraft systems, providing for fault tolerant engine control. Engine control problems simultaneously causing loss of thrust on up to three engines have been cited as causal in the crash of an Airbus A400M aircraft at Seville Spain on 9 May 2015. Airbus Chief ...
The JTF14 engine had been proposed for the C-5 Galaxy program but the production contract was awarded to the General Electric TF39. The engine's first test run took place in a test rig at East Hartford, Connecticut, with the engine's first flight in June 1968 mounted on a Boeing B-52 E which served as a JT9D flying testbed . [ 5 ]
Some engine control units (ECUs) also control the throttle position by electronic throttle control (ETC) or "drive by wire" systems, and if that is done, the position sensor is used in a feedback loop to enable that control. [1] Related to the TPS are accelerator pedal sensors, which often include a wide open throttle (WOT) sensor.