Search results
Results from the WOW.Com Content Network
Balloon skewer experiment. A pin or needle is frequently used to pop a balloon. [4] As the needle or pin creates a hole on the balloon surface, the balloon pops. However, if tape is placed on the part where the hole is created, the balloon will not pop since the tape helps reinforce the elastic tension in that area, preventing the edges of the hole pulling away from the center. [5]
Weather balloons that do not carry an instrument pack are used to determine upper-level winds and the height of cloud layers. For such balloons, a theodolite or total station is used to track the balloon's azimuth and elevation, which are then converted to estimated wind speed and direction and/or cloud height, as applicable.
Balloon rockets work because the elastic balloons contract on the air within them, and so when the mouth of the balloon is opened, the gas within the balloon is expelled out, and due to Newton's third law of motion, the balloon is propelled forward. This is the same way that a rocket works.
A ceiling balloon is a small, usually red, (fluted) rubber balloon commonly measuring 76 mm (3 in) across prior to inflation, inflated to ~40 cm (~15.75 in) diameter. After inflation the balloon is taken outside and released. By timing the balloon from release until it enters the cloud a ceiling height can be obtained.
Synchronized weather balloon launches have helped meteorologists create forecasts over the past 150 years, and now the old tradition is going high tech. Twice a day - every day of the year ...
When the valve is opened, the smaller balloon shrinks and the larger balloon expands. The two-balloon experiment is an experiment involving interconnected balloons. It is used in physics classes as a demonstration of elasticity. Two identical balloons are inflated to different diameters and connected by means of a tube.
Synchronized weather balloon launches have helped meteorologists create forecasts over the past 150 years, and now the old tradition is going high tech. Sensors beam data back down to Earth every ...
Walters quickly rose to nearly 3 miles (5 km), over 50 times his intended maximum altitude. Walters reportedly had planned to control his altitude by using a pellet gun to selectively pop some of the balloons. However, he was initially hesitant to shoot any balloons, as he was concerned about falling out due to a loss of stability.