Search results
Results from the WOW.Com Content Network
IGMP snooping is designed to prevent hosts on a local network from receiving traffic for a multicast group they have not explicitly joined. It provides switches with a mechanism to prune multicast traffic from links that do not contain a multicast listener (an IGMP client). Essentially, IGMP snooping is a layer 2 optimization for the layer 3 IGMP.
The Internet Group Management Protocol (IGMP) is a communications protocol used by hosts and adjacent routers on IPv4 networks to establish multicast group memberships. IGMP is an integral part of IP multicast and allows the network to direct multicast transmissions only to hosts that have requested them.
In support of link-local multicasts which do not use IGMP, any IPv4 multicast address that falls within the *.0.0.0 / 24 and *.128.0.0 / 24 ranges will be broadcast to all ports on many Ethernet switches, even if IGMP snooping is enabled, so addresses within these ranges should be avoided on Ethernet networks where the functionality of IGMP ...
However, in multicast routing, the source address (which is a simple unicast address) is used to determine data stream direction. The source of the multicast traffic is considered upstream. The router determines which downstream interfaces are destinations for this multicast group (the destination address), and sends the packet out through the ...
Multicast is the most common approach, and each VXLAN network identifier (VNI) is mapped to a single multicast group, while each multicast group may map to one or more VNIs. When a VTEP comes alive it uses the Internet Group Management Protocol to join the multicast groups for the VNIs it uses. When a VTEP has to send BUM traffic it will send ...
Source-specific multicast (SSM) is a method of delivering multicast packets in which the only packets that are delivered to a receiver are those originating from a specific source address requested by the receiver. By so limiting the source, SSM reduces demands on the network and improves security.
The solicited-node multicast addresses are generated from the host's IPv6 unicast or anycast address, and each interface must have a solicited-node multicast address associated with it. A solicited-node address is created by taking the least-significant 24 bits of a unicast or anycast address and appending them to the prefix ff02::1:ff00:0 / 104 .
In for example IP multicast, a multicast group is identified by a class D IP address. A host enters or exits a group using IGMP (Internet Group Management Protocol). [2] A message sent via multicast is sent to all nodes on the network, but only the intended nodes accept the multicast frames. [3]