enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. ISO 1 - Wikipedia

    en.wikipedia.org/wiki/ISO_1

    ISO 1 is an international standard set by the International Organization for Standardization that specifies the standard reference temperature for geometrical product specification and verification. The temperature is fixed at 20 degrees Celsius (°C), which exactly equals both 293.15 kelvin (K) and 68 degrees Fahrenheit (°F).

  3. Geometrical Product Specification and Verification - Wikipedia

    en.wikipedia.org/wiki/Geometrical_Product...

    Geometrical Product Specification and Verification (GPS&V) [1] is a set of ISO standards developed by ISO Technical Committee 213. [2] The aim of those standards is to develop a common language to specify macro geometry (size, form, orientation, location) and micro-geometry (surface texture) of products or parts of products so that the language can be used consistently worldwide.

  4. List of ISO standards - Wikipedia

    en.wikipedia.org/wiki/List_of_ISO_standards

    This is a list of published [note 1] standards and other deliverables of the International Organization for Standardization (ISO). [note 2] For a complete and up-to-date list of all the ISO standards, see the ISO catalogue. [1] The standards are protected by copyright and most of them must be purchased.

  5. List of ISO standards 2000–2999 - Wikipedia

    en.wikipedia.org/wiki/List_of_ISO_standards_2000...

    ISO 2809:1976 Paints and varnishes — Determination of light fastness of paints for interior use [Withdrawn: replaced with ISO 11341, now replaced with ISO 16474-(1-2)] ISO 2810:2020 Paints and varnishes — Natural weathering of coatings — Exposure and assessment; ISO 2811 Paints and varnishes — Determination of density

  6. List of ISO standards 1–1999 - Wikipedia

    en.wikipedia.org/wiki/List_of_ISO_standards_1–1999

    ISO 801-1:1994 Part 1: Pulp baled in sheet form; ISO 801-2:1994 Part 2: Pulps (such as flash-dried pulps) baled in slabs; ISO 801-3:1994 Part 3: Unitized bales; ISO 802:1976 Aluminium oxide primarily used for the production of aluminium — Preparation and storage of test samples [Withdrawn: replaced with ISO 23028]

  7. Check sheet - Wikipedia

    en.wikipedia.org/wiki/Check_sheet

    A check sheet is a form (document) used to collect data in real time at the location where the data is generated. The data it captures can be quantitative or qualitative. When the information is quantitative, the check sheet is sometimes called a tally sheet. [1] The check sheet is one of the so-called Seven Basic Tools of Quality Control. [2]

  8. Category:ISO standards - Wikipedia

    en.wikipedia.org/wiki/Category:ISO_standards

    List of International Organization for Standardization standards, 9000–9999; List of International Organization for Standardization standards, 11000–11999

  9. Engineering tolerance - Wikipedia

    en.wikipedia.org/wiki/Engineering_tolerance

    The actual amount bigger/smaller depends on the base dimension. For a shaft of the same size, h6 would mean 10+0−0.009, which means the shaft may be as small as 0.009 mm smaller than the base dimension and 0 mm larger. This method of standard tolerances is also known as Limits and Fits and can be found in ISO 286-1:2010 (Link to ISO catalog).