Search results
Results from the WOW.Com Content Network
Tomato is a family of community-developed, custom firmware for consumer-grade computer networking routers and gateways powered by Broadcom chipsets.The firmware has been continually forked and modded by multiple individuals and organizations, with the most up-to-date fork provided by the FreshTomato project.
An Ethernet crossover cable is a crossover cable for Ethernet used to connect computing devices together directly. It is most often used to connect two devices of the same type, e.g. two computers (via their network interface controllers ) or two switches to each other.
In this configuration, an Ethernet connection includes Power over Ethernet (PoE) (gray cable looping below), and a PoE splitter provides a separate data cable (gray, looping above) and power cable (black, also looping above) for a wireless access point. The splitter is the silver and black box in the middle between the wiring junction box (left ...
Early Ethernet used various grades of coaxial cable, but in 1984, StarLAN showed the potential of simple unshielded twisted pair. This led to the development of 10BASE-T and its successors 100BASE-TX, 1000BASE-T, 10GBASE-T and 40GBASE-T, supporting speeds of 10 and 100 megabit per second, then 1, 10 and 40 gigabit per second respectively. [a]
Distributed multi-link trunking (DMLT) or distributed MLT is a proprietary computer networking protocol designed by Nortel Networks, and now owned by Extreme Networks, [8] used to load balance the network traffic across connections and also across multiple switches or modules in a chassis.
The Etherlink III 3C509B-Combo is registered with the FCC ID DF63C509B. The main components on the card are Y1: crystal oscillator 20 MHz, U50: coaxial transceiver interface DP8392, U4: main controller 3Com 9513S (or 9545S etc.), U6: 8 kB 70 ns CMOS static RAM, U1: DIP-28 27C256 style EPROM for boot code, U3: 1024 bit 5V CMOS Serial EEPROM (configuration).
A sending station (computer or network switch) may be transmitting data faster than the other end of the link can accept it. Using flow control, the receiving station can signal the sender requesting suspension of transmissions until the receiver catches up. Flow control on Ethernet can be implemented at the data link layer.
A couple of managed D-Link Gigabit Ethernet rackmount switches, connected to the Ethernet ports on a few patch panels using Category 6 patch cables (all installed in a standard 19-inch rack) Centralized configuration management and configuration distribution; Enable and disable ports; Link bandwidth and duplex settings