enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. AC power plugs and sockets - Wikipedia

   en.wikipedia.org/wiki/AC_power_plugs_and_sockets

   These are used for both 220-volt and 127-volt regions of the country, despite the IEC 60906-2 recommendation that NEMA 5-15 be used for 120 V connections. There are two types of sockets and plugs in NBR 14136: one for 10 A, with a 4.0 mm pin diameter, and another for 20 A, with a 4.8 mm pin diameter. [13]

3. Mains electricity - Wikipedia

   en.wikipedia.org/wiki/Mains_electricity

   AC circuits adopted the same form during the war of the currents, allowing lamps to be run at around 110 V and major appliances to be connected to 220 V. Nominal voltages gradually crept upward to 112 V and 115 V, or even 117 V. [citation needed] After World War II the standard voltage in the U.S. became 117 V, but many areas lagged behind even ...

4. NEMA connector - Wikipedia

   en.wikipedia.org/wiki/NEMA_connector

   An LCDI cord has a fine wire mesh around the conductors, and circuitry to detect current leaking from the conductors to the mesh, which would happen if the cord were damaged or frayed. The plugs are normal NEMA 5-15, 5-20, 6-15, 6-20, or 6-30 plugs, depending on the air conditioner design, and are typically molded-on designs.

5. Split-phase electric power - Wikipedia

   en.wikipedia.org/wiki/Split-phase_electric_power

   Single-pole circuit breakers feed 120 V circuits from one of the 120 V buses within the panel, or two-pole circuit breakers feed 240-volt circuits from both buses. 120 V circuits are the most common, and used to power NEMA 1 and NEMA 5 outlets, and most residential and light commercial direct-wired lighting circuits.

6. AC power plugs and sockets: British and related types

   en.wikipedia.org/wiki/AC_power_plugs_and_sockets:...

   The International Electrotechnical Commission publishes IEC 60050, the International Electrotechnical Vocabulary. [2]Generally the plug is the movable connector attached to an electrically operated device's mains cable, and the socket is fixed on equipment or a building structure and connected to an energised electrical circuit.

7. Alternating current - Wikipedia

   en.wikipedia.org/wiki/Alternating_current

   A schematic representation of long distance electric power transmission. From left to right: G=generator, U=step-up transformer, V=voltage at beginning of transmission line, Pt=power entering transmission line, I=current in wires, R=total resistance in wires, Pw=power lost in transmission line, Pe=power reaching the end of the transmission line, D=step-down transformer, C=consumers.