enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Riveting machine - Wikipedia

    en.wikipedia.org/wiki/Riveting_machine

    This action causes the end of the rivet to roll over in the rollset which causes the end of the rivet to flare out and thus join the materials together. Impact riveting machines are very fast and a cycle time of 0.5 seconds is typical. Example of a 4-step orbital rivet Diagram of how an orbital riveting works

  3. Countersink - Wikipedia

    en.wikipedia.org/wiki/Countersink

    In manufacturing, a countersink (symbol: ⌵) is a conical hole cut into a manufactured object, or the cutter used to cut such a hole. A common use is to allow the head of a countersunk bolt , screw or rivet , when placed in the hole, to sit flush with or below the surface of the surrounding material (by comparison, a counterbore makes a flat ...

  4. Rivet - Wikipedia

    en.wikipedia.org/wiki/Rivet

    A drive rivet is a form of blind rivet that has a short mandrel protruding from the head that is driven in with a hammer to flare out the end inserted in the hole. This is commonly used to rivet wood panels into place since the hole does not need to be drilled all the way through the panel, producing an aesthetically pleasing appearance.

  5. Saw chain - Wikipedia

    en.wikipedia.org/wiki/Saw_chain

    The semi-chisel chain has teeth with rounded corners formed by a radius between the top and side plates. While slower than full chisel in softwood, it retains an acceptable cutting sharpness longer, making it the preferred choice for dirtier wood, hard or dry wood, frozen wood or stump work, all of which would rapidly degrade full chisel chain ...

  6. Spotface - Wikipedia

    en.wikipedia.org/wiki/Spotface

    In manual machining especially, the former is useful because its pilot guides the cutter into the correct location (established by the bolt hole), and its cutting lips are perpendicular to the hole axis with no relief angle, meaning that a plunging cut, moving in only the Z-axis, will leave a flat surface.

  7. Rivet gun - Wikipedia

    en.wikipedia.org/wiki/Rivet_gun

    The rivet gun is used on rivet's factory head (the head present before riveting takes place), and a bucking bar is used to support the tail of the rivet. The energy from the hammer in the rivet gun drives the work and the rivet against the bucking bar. As a result, the tail of the rivet is compressed and work-hardened.

  8. Router (woodworking) - Wikipedia

    en.wikipedia.org/wiki/Router_(woodworking)

    Owing to inertia at these high speeds, the normal wood cutting mechanism of Type I chips cannot take place. The cutter edge angle is blunt, approaching 90°, and so a Type III chip forms, with waste material produced as fine dust. This dust is a respiratory hazard, even in benign materials.

  9. Drill bit - Wikipedia

    en.wikipedia.org/wiki/Drill_bit

    An adjustable wood bit, also known as an expansive wood bit, has a small center pilot bit with an adjustable, sliding cutting edge mounted above it, usually containing a single sharp point at the outside, with a set screw to lock the cutter in position. When the cutting edge is centered on the bit, the hole drilled will be small, and when the ...