Search results
Results from the WOW.Com Content Network
The light normally appears when the vehicle ignition is turned on, but the engine is not running, as it detects no oil pressure due to the oil pump not operating (the oil pump is powered off the crankshaft, so only operates when the engine is running). It normally turns off a few seconds after engine start as the oil pump starts working and ...
Headlight flashing is the act of either briefly switching on the headlights of a car, or of momentarily switching between a headlight's high beams and low beams, in an effort to communicate with another driver or drivers. The signal is sometimes referred to in car manufacturers' manuals as an optical horn, since it draws the attention of other ...
A check engine light or malfunction indicator lamp (MIL), is a tell-tale that a computerized engine-management system uses to indicate a malfunction or problem with the vehicle ranging from minor (such as a loose gas cap) to serious (worn spark plugs, engine problems or a faulty oil valve, etc.).
The first car registered to drive on the road with full LED rear lights was Land Rover's LCV 2/3 concept car in the 1990s. [143] At the time, the only light function that was difficult to reproduce was the reverse light, as white LEDs did not yet exist.
A daytime running lamp (DRL, also daytime running light) is an automotive lighting and bicycle lighting device on the front of a road going motor vehicle or bicycle. [1] It is automatically switched on when the vehicle's handbrake has been pulled down, when the vehicle is in gear , or when the engine is started, emitting white, yellow , or ...
A common use of a strobe flash is to optimize a car engine's efficiency at a certain rotational period by directing the strobe-light towards a mark on the flywheel on the engine's main axle. The strobe-light tool for such ignition timing is called a timing light. Strobe lighting has also been used to see the movements of the vocal cords in slow ...
Detailed view of a Beacon light on a Tu-154 Beacon lights are flashing red lights fitted on the top and bottom fuselage of an aircraft usually on larger passenger aircraft. Their purpose is to alert ground crew and other aircraft that an engine is starting up, running or shutting down, or that the aircraft is about to start moving.
Mercury-free Integral ignitor For reflector systems D3S PK32d-5 42 V / 35 W Mercury-free Integral ignitor For projector systems D4R P32d-6 42 V / 35 W Mercury-free For reflector systems D4S P32d-5 42 V / 35 W Mercury-free For projector systems D5S PK32d-[7] 12 V: 25 W Ballast output voltage D6S P32d-1 42 V: 25 W D7S PK32d-1 42 V: 25 W D8S PK32d-1