Search results
Results from the WOW.Com Content Network
An interrupt vector table (IVT) is a data structure that associates a list of interrupt handlers with a list of interrupt requests in a table of interrupt vectors. Each entry of the interrupt vector table, called an interrupt vector, is the address of an interrupt handler (also known as ISR). While the concept is common across processor ...
In computer systems programming, an interrupt handler, also known as an interrupt service routine or ISR, is a special block of code associated with a specific interrupt condition. Interrupt handlers are initiated by hardware interrupts, software interrupt instructions, or software exceptions , and are used for implementing device drivers or ...
The processor reserves low memory addresses for two-word vectors that give a program counter and processor status word with which to begin a service routine. When an I/O device interrupts a program, it places the address of its vector on the bus to indicate which service routine should take control. The lowest vectors are service routines to ...
A hardware interrupt is a condition related to the state of the hardware that may be signaled by an external hardware device, e.g., an interrupt request (IRQ) line on a PC, or detected by devices embedded in processor logic (e.g., the CPU timer in IBM System/370), to communicate that the device needs attention from the operating system (OS) [7] or, if there is no OS, from the bare metal ...
In computer science, a vectored interrupt is a processing technique in which the interrupting device directs the processor to the appropriate interrupt service routine. This is in contrast to a polled interrupt system, in which a single interrupt service routine must determine the source of the interrupt by checking all potential interrupt ...
The interrupt descriptor table (IDT) is a data structure used by the x86 architecture to implement an interrupt vector table. The IDT is used by the processor to determine the memory addresses of the handlers to be executed on interrupts and exceptions. The details in the description below apply specifically to the x86 architecture.
The IRR specifies which interrupts are pending acknowledgement, and is typically a symbolic register which can not be directly accessed. The ISR register specifies which interrupts have been acknowledged, but are still waiting for an end of interrupt (EOI). The IMR specifies which interrupts are to be ignored and not acknowledged.
Trampoline can be used to overcome the limitations imposed by a central processing unit (CPU) architecture that expects to always find vectors in fixed locations. When an operating system is booted on a symmetric multiprocessing (SMP) machine, only one processor, the bootstrap processor, will be active. After the operating system has configured ...